Classic Car Stereo CR017 Classic 200 Benutzerhandbuch - Seite 10
Blättern Sie online oder laden Sie pdf Benutzerhandbuch für Car Stereo System Classic Car Stereo CR017 Classic 200 herunter. Classic Car Stereo CR017 Classic 200 16 Seiten. Dab dab+ fm rds usb bluetooth hands free & streaming aux in radio

- 1. Table of Contents
- 2. Audio Source Selection
- 3. Dab / Dab
- 4. FM Radio
- 5. Bluetooth Music Streaming
- 6. Bluetooth Hands Free Mobile Phone
- 7. Auxiliary Input
- 8. Usb
- 9. Ipod Mode
- 10. Installation
- 11. Mounting the Radio
- 12. Diagnostics
- 13. Diagnostics
- 14. Wiring Diagram
- 15. Dimensioned Drawing
- 16. Electrical Connections
Installation
ISO Connector B
Purple
Purple/black
Grey
Grey/black
White
White/black
Green
Green/black
If you have only two speakers then the un used speaker wires must be insulated and
not connected. It does not matter whether you use the front or the rear speaker
wires.
Any speakers that share a common connection/earth must be re wired separately
otherwise damage may occur to the radio.
The radio is designed to operate either two or four speakers or one of our DVC (dual
Voice Coil) speakers. It should not be connected to a single speaker on one channel.
The red accessory wire A7 may be connected to a permanent power supply along
with the yellow A4 if there is no accessory position on your vehicle.
The accessory connection ( red wire pin no A7) on your Classic 200 is protected with
a 10 amp fuse located the rear case next to the wiring connector. We recommend
fitting a separate 5 amp fuse in the permanent power supply ( yellow wire pin no A4).
If the power supply to your Classic 200 is disconnected then any settings and radio
stations that you have programmed will be retained.
Sub Woofer connection
The sub woofer line output connection is a green phono connector on a fly lead at
the rear of the radio and will provide a line out signal for an optional sub woofer/
amplifier. The volume of the sub woofer can then be adjusted in the audio settings.
(-10 to + 10) The sub woofer volume is not affected by the " fader" setting
Hands free microphone
The hands free microphone should be mounted in front of the driver either at the
top or bottom of the windscreen pillar or on the dashboard in a convenient location.
10
B1
Right rear speaker positive
B2
Right rear speaker negative
B3
Right front speaker positive
B4
Right front speaker negative
B5
Left front speaker positive
B6
Left front speaker negative
B7
Left rear speaker positive
B8
Left rear speaker negative