Arnica HEPATECH AQUA Gebrauchsanweisung - Seite 9

Blättern Sie online oder laden Sie pdf Gebrauchsanweisung für Staubsauger Arnica HEPATECH AQUA herunter. Arnica HEPATECH AQUA 12 Seiten. Water filter vacuum cleaner
Auch für Arnica HEPATECH AQUA: Gebrauchsanweisung (12 seiten)

Seite drucken

INSTRUCTIONS MANUAL

Thank you for choosing our product. This instructions manual has

been prepared for you to achieve complete satisfaction and maximum

performance from your product

READ THESE INSTRUCTIONS CAREFULLY BEFORE USING THE APPLIANCE

AND KEEP THE MANUAL FOR FUTURE REFERENCE

CONTENTS

I. IMPORTANT SAFETY & USAGE INSTRUCTIONS

II. GENERAL DESCRIPTION

III. TECHNICAL SPECIFICATIONS

IV. PREPARING FOR USE

V. USING THE APPLIANCE

VI. CLEANING & MAINTENANCE

I. IMPORTANT SAFETY & USAGE INSTRUCTIONS

• Check if the voltage indicated on the type plate sticker (located under

the wheel group) corresponds to the local mains voltage before you

conect the appliance.

• Unless management and supervision regarding the device are

ensured by a person responsible for safety of the devices, this

device isn't designed to be used by physically and mentally disabled

people (including children) or by people who are lack of experience

and knowledge.

• Children must be supervised in order to ensure keeping them away

from the device.

• The appliance should only be connected to power outlets which are

suitably with minimum 10 Amp fuse.

• Do not insert the mains plug into the wall socket until the appliance

is completely ready for use.

• Always remove the mains plug from the wall socket when you are

not operating the appliance.

• Appliance musn't be used if the cord or plug is damaged, if any

defects are present of if you have dropped the unit or have broken

any of its parts. I such cases, you must take it to a service center

to be checked, repaired or adjusted.

• Do not allow the appliance to pass over the cable as this may

damage the insulating shield.

• Keep the appliance out of reach of children

• Never use appliance without the foam filter

• Never immerse the motor unit in water

• Do not attempt to use the appliance if it appears to be defective.

• Always switch the appliance off after use and remove the

mains plug from the wall socket.

• Always empty, clean and dry container after wet use. Let the

appliance suck in dry air for few minutes to dry the inside

of the tubes and hose. This prevents unpleasent smell and

prevents the paper dust bag from becoming wet.

• Do not point the hose at the eyes or ears nor put it in your

mouth when the appliance is switched on.

• Take particular care when cleaning stairs.

• Switch off immediately in the event of leaking liquid .

• Use only original accessories and spare parts to ensure the

perfect performance of your cleaner and to benefit from the

guarantee.

• For repairs or spare parts, contact your local service agents.

WARNING : Never use the appliance to clean up flammable or explosive

solvents, object soaked with such solvents, explosive dusts, liquids

such as petrol, oil, alcohol, thinners and objects that are hotter than 60

oC, as this will cause a serious explosion and fire hazard! The appliance

must not be used near flammable substances and must not be used

to clean up health endangering dust.

II. GENERAL DESCRIPTION

Main parts of the appliance are shown as follows (Figure 1)

A. MOTOR UNIT

This group contains motor, switch and operating units on. Top of this

group, there is a HEPA FILTER which filters dust and other particles from

blowing air. If you remove the foam filter, you will see a large plastic

float in a case. As the container fills, this plastic float rises up and cuts

off the vacuum action to warn you when the container needs emptying.

1 - On/Off switch

A2 - Hepa filter housing

A3 - Hepa filter

A4 - Hepa filter housing cover

A5 - Dust level indicator

A6 - Float group

A7 - Foam filter

A8 - Clamp Housing

C. HOSE GROUP

This group contains suction hose with hand grip and suction tubes.

Suction nose is connected to container group by inserting the suction

hose into the suction inlet. Suction tubes are connected to hand

grip if necessary. Handgrip contains a manual sliding for regulating

suction power. Hose group can be placed onto the motor unit by the

help of hanger.

C1 - Suction hose

C2 - Hand grip

C3 - Mechanical suction power control

C4 - Connecting part

C5 - Suction tube

C6 - Hanger

C7 - Nozzle

D. ACCESSORIES GROUP

There are various accessories for different cleaning purposes.

D1 - Accessories Holder

D2 - Crevice Nozzle

D3 - Round Nozzle

D4 - Small Nozzle

D5 - Perfume

III. TECHNICAL SPECIFICATIONS

Voltage

: 230V~, 50Hz

Power

: 2400 W Max.

Electric Insulation Class : II

Degree of Protection

: IPX4

Cord Length

: 6m

Used Life

: 10 Year

Max. Noise Level

: Less than 70 dB (A) EN ISO 7779