Cubicon 3DP-110F Schnellstart-Handbuch - Seite 11

Blättern Sie online oder laden Sie pdf Schnellstart-Handbuch für 3D-Drucker Cubicon 3DP-110F herunter. Cubicon 3DP-110F 12 Seiten.

This section describes the printing of an actual sample using the sample slicing file (G-code file) in the

supplied SD memory card after the printer is installed.

Before you print the sample, you are recommended to carefully read the latest operation manual

inside the SD card, or downloaded from Cubicon homepage (www.3dcubicon.com).

① Mount the filament spool to the spool carrier of the

printer and insert the filament all the way into the

Teflon tube inside the printer.

③

Press

"Check

Filament".

Filament" is displayed, and the following

messages are displayed in sequence.

Set the temperature to 240℃.

During the loading process, filament with a different color from the mounted filament may

appear. This is residue from factory testing, and is normal.

This document is the Quick Start Guide (141020,kr), and is subject to change without notice when necessary for

product improvements. HyVISION System does not take the responsibility for loss caused by any error in the

document or provisions and use of this document.

② Turn on the printer. Since there is no filament in the

extruder initially, "No Filament" is displayed.

Press the 【ENTER】 button to initiate the function

menu. "Check Filament" flickers.

④ Press the 【BACK】 button and select "Load filament". The

"Unload

following messages are displayed in sequence.

temperature to 240℃.

Initial Printing (1/2)

Set the