3D R DIY QUAD Montageanleitung - Seite 3

Blättern Sie online oder laden Sie pdf Montageanleitung für Flugzeuge 3D R DIY QUAD herunter. 3D R DIY QUAD 12 Seiten.

Seite drucken

You may have opted to also receive:

3DR APM 2.6:

3DR APM 2.6

Telemetry adapter

cable

FR AME A SS EMB LY

Choose + or x

Your 3DR Quad can be flown in both + (plus)

and x (cross) configurations. A plus-configured

copter flies with one arm forward, while a

cross-configured copter flies with two arms

forward. While both configurations provide

excellent performance, cross is standard and

recommended for new fliers. For plus, use three

black arms and one blue arm when assembling your copter, and remember to specify plus

when choosing your frame orientation during software configuration. These instructions will

continue assembling a Quad in cross orientation.

Attach motors to arms

Each arm of your Quad will have a motor attached to the top of the arm using two 5 mm steel

bolts and two metal lock washers. To ensure motors are securely bolted to arms, apply a

small amount of threadlock to each bolt before fastening.

Threadlocking compound is an important component to ensure your motors remain

firmly attached! For application tips, check out this video:

Position holes in the bottom of the motor over the

two small holes on either side of the larger hole in

top in the of the arm. Secure with two 5 mm steel

bolts (with a metal lock washer on each bolt) by

accessing through the two large holes in the bottom

of the arm. Thread the motor cables through the arm

using the hole in the side of the arm. Repeat for all

four arms.

3DR Radio:

4 mm JP1

jumper connector

6 mm PPM

jumper connector

Micro USB cable

3DR uBlox GPS+Compass:

Radios (2)

Antennas (2)

Micro-USB cable

Android OTG cable

3DR uBlox GPS

Autopilot connectors

board with compass

x (cross) configuration

Thread

cables

6-position to

5-position GPS

cable

4-position compass

cable

+ (plus) configuration

goo.gl/bM3MA.

5 mm bolts

and lock

washers