Disney FR-346.2 Handbuch

Blättern Sie online oder laden Sie pdf Handbuch für Wecker Disney FR-346.2 herunter. Disney FR-346.2 2 Seiten. Night glow alarm clock

Seite drucken

Getting Started

Setting & Using the Alarm

Installing/Replacing the Batteries

3. Scroll to your desired alarm time using the Forward and

Reverse Buttons. Make sure to set the correct AM/PM

This unit requires 3 AA batteries (not included)

alarm time. The PM indicator appears at the bottom left of

the display; there is no AM indicator.

Note: Batteries should always be installed by an adult.

When the Low Battery icon appears on the lower right of the

4. Once you have selected a time, press the Alarm Set

display, it's time to replace the batteries.

Button again. Two beeps will sound to confirm alarm

setting.

³ Use a Phillips screwdriver to open the battery compartment

door located on the back of the unit.

5. The alarm sounds for 15 minutes. When the alarm is

· Insert 3 AA batteries into the clock with + and - terminals as

sounding, press the Alarm Reset Button to reset the alarm

indicated in the compartment.

to come on the next day at the same time. To disarm the

» Replace the compartment door and tighten the screw with a

alarm, slide the Alarm ON/OFF Switch on the back of

Phillips screwdriver. Do not over-tighten the screw.

the unit to 'OFF'. The alarm indicator will vanish from the

display.

For the Best Possible Performance

• We recommend the use of alkaline batteries for longer life.

Snooze/Night Light Button

• Do not mix old and new batteries.

• Do not mix alkaline, standard (carbon-zinc) or rechargeable

Alarm/Snooze Function:

(nickel-cadmium) batteries.

• Batteries are to be inserted with correct polarity.

When the alarm is sounding, press the Snooze/Night Light

Button to activate a 7 minute snooze cycle before the alarm

• Remove exhausted batteries from the unit.

• Do not attempt to recharge non-rechargeable batteries.

sounds again. Snooze can be pressed several times during the

• Remove rechargeable batteries from the unit before charging.

1 hour alarm cycle.

• The supply terminals are not to be short-circuited.

Night Light Function:

• Batteries should be removed if the item will not be used for an

The Night Light can be activated before you go to sleep. When

extended period of time, such as a month or longer, to prevent

the alarm is not sounding (or the snooze feature is inactive)

battery leakage or damage.

• Rechargeable batteries should only be charged under adult

press the Snooze/Night Light Button to cycle through 5, 10,

and 15 minute or OFF night light periods. Select the desired

supervision.

• Only batteries of the same or equivalent type as recommended

time and the unit will turn off the light automatically. Selecting

are to be used.

OFF will disable the Night Light function.

Troubleshooting

Setting the Time

If the clock does not work, this may indicate that the batteries are

weak. Insert 3 new AA batteries into the unit.

1. Press and hold the Time Set Button until the clock display

If problems persist, DO NOT ATTEMPT TO REPAIR THE UNIT.

begins to flash and a beep sounds.

See the Warranty for factory services.

2. Scroll to your desired time using the Forward and Reverse

Buttons. Make sure to set the correct AM/PM time. The PM

Questions or Comments

indicator appears at the bottom left of the display; there is

no AM indicator.

• For questions or comments regarding this or other KIDdesigns

products, please call our toll-free number: 1-888-TOP-TOYS.

3. Once you have selected a time, press the Time Set

Also visit our website: www.kiddesigns.com

Button again. Two beeps will sound to confirm time setting.

If problems persist, please do not attempt to repair unit; see

warranty for factory service.

Setting & Using the Alarm

Maintenance

1. Find the Alarm ON/OFF Switch on the back of the unit

and slide it to 'ON'. The alarm indicator will appear on the

It is important to keep the alarm clock as dry and clean as possible.

upper left of the display.

You may clean the cabinet with a cloth or sponge moistened with

mild soap and water. Do not attempt to use strong cleansers or

2. Press and hold the Alarm Set Button until the clock display

solvents, as they may cause damage.

and alarm indicator begin to flash and a beep sounds.

Alarm ON/OFF Switch /

Interruptor ON/OFF de la Alarma para activar o desactivarla /

Commutateur d'alarme marche/arrêt

DISPLAY / PANTALLA / ECRAN

Alarm Indicator / Indicador de la Alarma /

Indicateur d'alarme

1.5V

AA SIZE

PM Indicator /

Low Battery Indicator /

1.5V

AA SIZE

Indicador PM /

Indicador Batería Baja /

Indicateur PM

Indicateur de niveau de pile bas

Alarm ON/OFF Switch /

Interruptor ON/OFF de

la Alarma para activar

o desactivarla /

Commutateur d'alarme

marche/arrêt

Forward Button /

Snooze/Night Light Button /

Botones de avance /

Botón para repetir la Alarma/activar

Boutons Avance

Luz Luminiscente /

Touche Rappel d'alarme/Veilleuse

Alarm Reset Button /

Botón para volver a configurar

la Alarma /

Reverse Button / Retroceso / Retour

Touche réinitialiser l'alarme /

Alarm Set Button / Botón para configurar la Alarma /

Time Set Button /

Touche Régler l'alarme

Botón para configurar la Hora /

Touche Régler l'heure

FCC Information

Limited One-Year Warranty

KIDdesigns, a division of SDI Technologies Inc. (hereafter referred to as

This device complies with Part 15 of the FCC rules. Operation is

SDI), warrants this product to be free from defects in workmanship and

subject to the following two conditions: (1) this device may not

materials, under normal use and conditions, for a period of one (1) year

cause harmful interference, and (2) this device must accept any

from the date of original purchase.

interference received, including interference that may cause

Should this product fail to function in a satisfactory manner, it is best to

undesired operation.

first return it to the store where it was originally purchased. Should this fail

to resolve the matter and service still be required by reason of any defect

NOTE: This equipment has been tested and found to comply with

or malfunction during the warranty period, SDI will repair or, at its

the limits for a Class B digital device, pursuant to Part 15 of the

discretion, replace this product without charge. This decision is subject to

verification of the defect or malfunction upon delivery of this product to the

FCC rules. These limits are designed to provide reasonable

Factory Service Center authorized by SDI Customer Service. The product

protection against harmful interference in a residential installation.

must include proof of purchase, including date of purchase. An

This equipment generates, uses, and can radiate radio frequency

out-of-warranty fee for service will be charged for units that are received

energy and, if not installed and used in accordance with the

without proof of purchase.

instructions, may cause harmful interference to radio

Before returning this product for service, please first replace the batteries

communications. However, there is no guarantee that interference

(if applicable) with fresh ones, as exhausted or defective batteries are the

will not occur in a particular installation. If this equipment does

most common cause of problems encountered.

cause harmful interference to radio or television reception, which

If service is still required:

1. Call SDI Customer Service at 1-888-TOP-TOYS (1-888-867-8697)

can be determined by turning the equipment off and on, the user

for Return Authorization and for the address of the Factory Service

is encouraged to try to correct the interference by one or more of

Center.

the following measures:

2. Remove the batteries (if applicable) and pack the unit in a well

padded, heavy corrugated box. SDI is not responsible for damage

• Reorient or relocate the receiving antenna.

that occurs during shipping to the Factory Service Center.

3. Enclose a photocopy of your sales receipt, credit card statement, or

• Increase the separation between the equipment and receiver.

other proof of the date of purchase, if within the warranty period. Also

• Connect the equipment into an outlet on a circuit different from

include your name and address information, a brief description for

why the unit is being returned, and the return authorization number.

that to which the receiver is connected.

No unit can be processed without a return authorization number.

• Consult the dealer or an experienced radio/TV technician for

4. Write the return authorization number on the side of the shipping

help.

package and send the unit prepaid and insured to the Factory

Service Center address authorized by SDI Customer Service.

WARNING: Changes or modifications to this unit not expressly

Disclaimer of Warranty

approved by the party responsible for compliance could void the

NOTE: This warranty is valid only if the product is used for the purpose for

user's authority to operate the equipment.

which it was designed. It does not cover (i) products which have been

damaged by negligence or willful actions, misuse or accident, or which

CAN ICES-3 (B)/NMB-3(B)

have been modified or repaired by unauthorized persons; (ii) cracked or

broken cabinets, or units damaged by excessive heat; (iii) damage to

digital media players, CD's or tape cassettes (if applicable); (iv) the cost of

shipping this product to the Factory Service Center and its return to the

owner.

This warranty is valid only in the United States of America and does not

extend to owners of the product other than to the original purchaser. In no

event will SDI or any of its affiliates, contractors, resellers, their officers,

directors, shareholders, members or agents be liable to you or any third

party for any consequential or incidental damages, any lost profits, actual,

exemplary or punitive damages. (Some states do not allow limitations on

implied warranties or exclusion of consequential damages, so these

restrictions may not apply to you.) This warranty gives you specific legal

rights, and you may also have other rights which vary from state to state.

Your acknowledgment and agreement to fully and completely abide by

the above mentioned disclaimer of warranty is contractually binding to

you upon your transfer of currency (money order, cashier's check, or

credit card) for purchase of your SDI product.

Questions? Visit www.kiddesigns.com

or call 1-888-TOP-TOYS

Visit Disney.com

Distributed by KIDdesigns, Inc. Rahway, NJ 07065-5024

eKids is a wholly owned subsidiary of KidDesigns, Inc,

1299 Main Street Rahway NJ 07065

Printed in China

Model/Modelo/Modèle: FR-346.2

NIGHT GLOW ALARM CLOCK

RELOJ DESPERTADOR LUMINISCENTE

RÉVEIL À LUMINESCENCE NOCTURNE

Important Message to Customers

Thank you for purchasing one of Disney's many top-quality electronic products. We would appreciate it if you take a few

moments to read through these instructions. This will help you explain to the child the safe and proper way to use this

toy, and to help give it the long-lasting life that Disney products are designed for.

Mensaje importante para los clientes

Gracias por comprar uno de los productos electrónicos de calidad superior Disney. Apreciaríamos que se tomara

unos momentos para leer completamente estas instrucciones. Esto le ayudará a explicarles a los niños la forma

segura y apropiada de usar este juguete para que tenga la vida útil prolongada para la que están diseñados los

productos Disney.

Message important aux clients

Merci pour votre achat d'un des nombreux produits de qualité Disney. Nous vous conseillons de prendre quelques

minutes pour lire ces instructions. Elles vous indiquent comment expliquer à votre enfant la façon d'utiliser

correctement et sans danger cet appareil et comment lui donner la plus longue vie possible que tous nos produits

vous offrent.

FR346-3L-050214-A