3D Systems Figure 4 Standalone Einrichtung - Seite 3

Blättern Sie online oder laden Sie pdf Einrichtung für 3D-Drucker 3D Systems Figure 4 Standalone herunter. 3D Systems Figure 4 Standalone 4 Seiten.
Auch für 3D Systems Figure 4 Standalone: Schnellstart-Handbuch (2 seiten)

Seite drucken
3D Systems Figure 4 Standalone Einrichtung
Figure 4 Standalone
Please see the Figure 4 Standalone User Guide, found on the support.3dsystems.com/figure4standalone, for safe-
ty information and comprehensive operating instructions.
Save all foam and packing material for future use. Shipping without the original packing material may
cause damage to the printer.
7. Install Resin Tray
1
2
a
3
1.
Open the printer lid and front
door.
2.
Push in the tension-release button
(a) and lift the tension arm (b).
3.
Install resin tray in chassis, concave
side up and with fill lines in the
back (see
Initial Print
Guide). Low-
er the tension arm and push down
on it until it locks into place.
10. Add Printer
1
3
4
1.
Open 3D Sprint. Click the Printer icon if the Printer window is not already
open.
2.
Click Find Printer button to find printer on your network. If this fails, enter
the printer's IP address and press Enter. The IP address can be found on the
printer's touch screen on the Settings tab (above, right).
3.
Click the Figure 4 Standalone icon that the software just found.
4.
Click Next.
You will need to make the printer's IP address an exception on your
network's firewall, if applicable. Both the printer and the PC running 3D
Sprint must be on the same network and connected to the internet.
8. Power Printer On
2
b
1
1
1.
Plug in power cable and Ethernet
cable.
2.
Flip the power switch to the "I"
position to turn printer on.
3.
The printer will search for firmware
updates. Tap Install on the touch
screen to install them.
802.11n WiFi bridge >300Mbps
may be connected to ethernet
port.
2
®
Setup
3
9. Install 3D Sprint
1
2
1.
On a PC, go to
support.3dsystems.
com/figure4standalone.
stall Software link.
2.
Follow the instructions to down-
load/install 3D Sprint.
Ensure your computer can run
3D Sprint - See
User Guide
specs.
11. Select Material
2
1.
Click the icon for the resin you wish
to use.
2.
Click the Next button.
Click In-
for
1