Aerial AD 630F Gebrauchsanweisung - Seite 6

Blättern Sie online oder laden Sie pdf Gebrauchsanweisung für Trockner Aerial AD 630F herunter. Aerial AD 630F 18 Seiten. Condensation dryer

Seite drucken
Instruction manual condensation dryer AD 530 / AD 630 / AD 630F

6.2 Hygrostat control

The air dryers of the AD-series dispose of a hygrostat for setting the required humidity value.
This hygrostat is located in the hygrostat box inside the bucket compartment. It makes that the
air dryer cuts in as soon as the ambient humidity exceeds the preset value. If the humidity
value falls below the set value, the hygrostat will switch off the appliance.
The following operating modes can be set by means of the hygrostat:
1
0
Attention!
The marks at the rebound curve and the humidity values mentioned above are to be seen as
reference values only. The hygrostat of the air dryer and a hygrometer located inside the room
to be dried most probably will not indicate the same values. It is recommended to change the
setting at the air dryer until the desired room humidity has been reached.

6.3 Condensate outlet

The air dryers of the AD-series are serially equipped with water collecting tanks and with
fittings for 12 mm hoses. If the water collecting tank is used, the appliance will switch off
automatically when the tank is full, and the red lamp at the right side of the enclosure will light
up.
Attention!
The appliance should be disconnected before removing the water tank, so that no condensate
can accumulate on the floor of the room to be dried.
If a hose is used for the draining the condensate, it should be proceeded as follows:
Remove the bucket from the unit.
Attach cautiously the hose to the drain to the bottom of the defrosting tub. Apply no power.
If possible - attach cautiously the hose with a hose clamb. Apply no power.
Lead the hose optionally to the back or through the punctures in seesaw and ground down
from the device..
Attention!
The end of the hose must be situated lower than the beginning of the hose (runoff socket)!
The hose must never be bent!
No objects must be placed onto the hose!
from serie July 2003
2
3
max
page 5
The mark on the rotary button points to
"0". The appliance is switched off. No air
drying.
The mark on the rotary button points to
"1". The appliance is in the air-drying
mode. An air humidity of abt. 70 % can be
obtained.
The mark on the rotary button points to
"2". The appliance is in the air-drying
mode. An air humidity of abt. 50 % can be
obtained.
The mark on the rotary button points to
"3". The appliance is in the air-drying
mode. An air humidity of less than 50 %
can be obtained.
The mark on the rotary button points to
"max.". The appliance is in the continuous
operating mode. A relative humidity of up
to 40 % can be obtained.
AERIAL GmbH