Aerial AB 200 Series Gebrauchsanweisung - Seite 6
Blättern Sie online oder laden Sie pdf Gebrauchsanweisung für Gebläse Aerial AB 200 Series herunter. Aerial AB 200 Series 12 Seiten. Sound box with high pressure blower
Seite drucken5. Installation and transport
The AB-sound boxes has been designed for mobile application. For installation and
transport, the following instructions must be adhered to:
The sound boxes must be installed so that the air can pass through it without
any obstacles. The side, reverse and front wall of the case must not be covered!
Before any change of the place of installation, the appliance is to be switched off
by the ON-OFF-switch, the mains plug is to be removed from the socket!
The sound box must be moved only using the provided handle system!
The appliance must be used exclusively for cavity drying.
Be careful while using on flammable grounds! Bottom of sound box case can get
warm.
ATTENTION:
Do never pull or move the device at the power cable
6.Operation
6.1 electrical connection
Before connecting the sound box, the following items must be checked:
Does the mains voltage coincide with the voltage of the appliance?
Adequate fusing of socket and supply system?
Has a residual-current-operated circuitbreaker (r.c.c.b) been installed?
If a cable drum is used: has it been unwound completely?
Is the appliance connector suitable for the building socket?
Is the socket provided with a perfect grounding?
ATTENTION:
Before putting the air dryer into operation, the technical data of the appliance
should be compared to the conditions prevailing in the room of installation!
6.2 Putting into operation
ATTENTION:
Before putting the sound box into operation, the instruction manual should be
studied carefully. Thus, damages by a false or inappropriate operation as well as
by inadequate environmental conditions can be avoided.
An air filter (serially equipped at this AB-series) is to be mounted on the
suction side if the sound box is used not in combination with an adsorption
dryer!
A permissible water separator is to be pre-connected always if the sound box
is used fur sucking.
page 6 of 12