Acoustic Energy AE1 Classic Benutzerhandbuch - Seite 3
Blättern Sie online oder laden Sie pdf Benutzerhandbuch für Redner Acoustic Energy AE1 Classic herunter. Acoustic Energy AE1 Classic 7 Seiten. Reference series mkiii loudspeakers
Auch für Acoustic Energy AE1 Classic: Spezifikationen (2 seiten), Broschüre (2 seiten), Benutzerhandbuch (4 seiten), Handbuch (12 seiten)
Seite drucken
The AE1 is intended to be used mounted on loudspeaker stands clear of
room boundaries. Alternative mounting arrangements such as wall
brackets are possible although these are likely to result in less good
performance. If wall brackets are to be used they should be as rigid as
possible and firmly attached to brick-built walls.
The construction style, rigidity and dimensions of the loudspeaker stands
are of critical significance to the performance of the AE1. Acoustic Energy
can supply appropriate stands for the AE1, however, these may not be
available in all territories. If this is the case the following specification will
help you select appropriate stands. Your retailer or distributor will also be
able to offer advice.
Construction Style:
Mass Loading:
Overall height:
Top plate Dimensions
Minimum width:
Maximum width:
Minimum depth:
Maximum depth:
Top plate to speaker interface: Direct coupled tri-point or damped-
Stand to floor interface:
Page 2
Direct coupled (minimum compliance),
single pillar preferred.
Preferred (sand fill).
0.56 - 0.64 m (AE1 top panel to be just
below head height when seated).
120 mm
175 mm
180 mm
230 mm
compliance.
Floor spikes (M8 minimum).
The position of loudspeakers within the listening
room is likely to have more influence over their
performance than any other aspect of their
installation. It is worth spending some time
experimenting with both the finer points of
positioning as well as the larger scale issues of
room layout.
If you are already familiar with the acoustic
characteristics of your listening room and the
way loudspeakers perform in it you may already
have a good feel for where to position your
AE1s. However, installing any new hi-fi
component provides a good opportunity to
review an existing set-up and perhaps make
improvements.
The fundamental position requirements for a
pair of AE1s installed in an averagely sized and
furnished listening room (say 5m x 6m) are as
follows:
•
Between 0.5 and 1 metre from the rear wall.
•
Minimum 1 metre from side walls.
•
Between 2.5 and 3.5 metres apart.
•
Well clear of corners.
•
Angled inwards by between 5 and 10
degrees.
As described in Section 3 above, they should be
mounted on stands around 0.6 metres high.
AE1s are magnetically shielded and can be used
in relatively close proximity to CRT screens.
While it is often the first instinct to position a
pair of loudspeakers against the shorter wall of a