CAMDEN Sure-Wave CM-333/N Einbauanleitung - Seite 2

Blättern Sie online oder laden Sie pdf Einbauanleitung für Schalter CAMDEN Sure-Wave CM-333/N herunter. CAMDEN Sure-Wave CM-333/N 4 Seiten. Battery operated with relay output active infra-red hands-free switches

Seite drucken

CM-333 Battery Operated with Relay Output Active Infra-red "Hands-Free" Switches Installation Instructions

Wall

Wall Box

Rough Wall

Finish

Recessed

Box

Diagram 1 - Proper Box Installation

2- GANG (or 4x4) ELECTRICAL BOX: CM-333W

1a – If using an in-wall box ensure the box is plumb

and square, and flush with the wall surface.

(See Diagram 1)

1b – If using a surface box, ensure it is secure & plumb.

1c – If using a 4 x 4 box, ensure the box is plumb and

square, and flush with the wall surface, then attach

the metal adaptor plate (included in the CM-333W

package) to the box using appropriate fasteners.

2 – Bring your 2-conductor wire through the back or

side of the enclosure and leave approximately 6" tail

for wiring connection.

3 – Make the electrical connections to the device

according to the wiring section (following).

4 – Using the dip switch located on the end of the unit,

set the operating mode. (See Section 4)

5 – Attach the unit to the enclosure using the two #6-32

screws provided.

6 – Attach the faceplate to the unit using the two black

#6-32 x 3/8 machine screws or tamperproof screws.

Do not overtighten!!

Smooth

Wall Finish

Flush

Unaligned

Box

Page 2 of 4

DOOR FRAME: CM-324N

1a – If mounting directly in a 1¾" wide aluminum jamb,

make a cutout in the door frame at the intended

location as per Diagram 3. (See Diagram 3 on

page 3)

Drill and tap two mounting holes as shown.

1b – If mounting the unit in our CM-23D deep jamb

box, first mount the jamb box according to the

instructions packaged with the enclosure. Using

the CM-23D as a guide, drill a wire access hole

through the jamb to fish the wiring through.

2 – Bring your 2-conductor wire through the back or

side of the enclosure and leave approximately 6" tail

for wiring connection.

3 – Make the electrical connections to the device

according to the wiring section (following).

4 – Using the dip switch located on the end of the unit,

set the operating mode. (See Section 4)

5 – Attach the unit to the enclosure or jamb using the

two #6-32 screws provided.

6 – Attach the faceplate to the unit using the two black

#6-32 x 3/8 machine screws or tamperproof screws.

Do not overtighten!!

Wiring

CAUTION: Do not apply power to the unit until all

secondary wiring is complete, and dip-switches have

been set.

The CM-333 is powered from 2 AA batteries (supplied).

The battery holder has been pre-installed. Insert the

batteries into the battery holder. Please be careful that

the polarity of the batteries is correct.

The CM-333 output is a form 'C' relay. Selecting the

correct output is also dependent on the operating

mode chosen. Most applications will utilize the N.O. and

Common terminals.

Diagram 2

Power In -

Power In +

Request To

Exit Input