Alto & Bass CE-GP002 Benutzerhandbuch - Seite 7

Blättern Sie online oder laden Sie pdf Benutzerhandbuch für Videospiel-Controller Alto & Bass CE-GP002 herunter. Alto & Bass CE-GP002 9 Seiten. Switch / switch lite / switch oled / pc / pc360 / android

Seite drucken

-Calibrate via Sticks

Calibrate via controller

When controller is power off, user put the controller on a flat surface, press and hold '-'

and 'A' for a while and then press "Home" button to turn on and enter calibration mode.

LED1-4 will flash circularly. Then press "+" to finish calibration.

-Calibrate on Switch console

1.Connect the controller to the console;

2.Enter the interface: "Setting" > "Controller and Sensors" > "Calibrate Motion Controls";

3.Then press "+" button to finish calibration.

Low voltage warning

The controller will alert when battery voltage is lower than 3.4V (according to the

principle of battery characteristics). The corresponding channel light will flash slowly to

indicate the battery is in low voltage and need to be charged. The controller will shut

down due to low battery when the voltage is lower than 3.3V.

Charging

1.When the controller is power off, plug adaptor into the controller, the LED 1-4 flash

circularly. After the controller has been full charged, LED 1-4 keep on.

2.When the controller is online, plug the USB into the controller, the corresponding

channel light flashes slowly to indicate different platform. After the controller has been

full charged, the light will keep on.

Power off

1.When connecting via Bluetooth, long press "Home" button for 5 seconds to shutdown

the controller;

2.When the screen of Switch console goes off, the controller will disconnect automati-

cally;

3.Enter the interface "Controller and Sensors" > "Change Grip/Order" and user can turn

off the controller in the settings;

4.When the controller is online, it will shut down automatically if there is no any operation

in 5 minutes;

5.When the controller is reconnecting, it will shut down automatically if fail to connect in

30 seconds;

6.When the controller is coding, it will shut down automatically if fail to connect in 145

seconds.