3DR Y6 Montageanleitung - Seite 3
Blättern Sie online oder laden Sie pdf Montageanleitung für Drohnen 3DR Y6 herunter. 3DR Y6 13 Seiten.
Auch für 3DR Y6: Schnellstart-Handbuch (8 seiten)
Seite druckenYou may have opted to also receive:
3DR APM 2.6:
3DR APM 2.6
Telemetry adapter
cable
FRA ME A S SE MBLY
1
Attach motors to arms
Each arm of your Y6 will have a top motor and a bottom motor attached to the arm using
co-axial motor mounting plates. To ensure motors are securely bolted to arms, apply a small
amount of threadlock to each bolt before fastening.
Threadlocking compound is an important component to ensure your motors remain
firmly attached! For application tips, check out this video:
Attach mounting plates to bottom motors:
Using two 6 mm steel bolts and one co-axial motor
mounting plate, fasten motor onto plate as shown.
Repeat for three of six motors.
25 mm
bolts
6 mm bolts
19 mm hollow
spacers
Top and bottom motors attached to
arm with mounting plates
3DR Radio:
4 mm JP1
jumper connector
6 mm PPM
jumper connector
Micro USB cable
Top motor
Mounting
plates
Bottom
motor
3DR uBlox GPS+Compass:
Radios (2)
Antennas (2)
Micro-USB cable
Android OTG cable
3DR uBlox GPS
Autopilot connectors
board with compass
Secure with
6 mm bolts
Attach top motors to arms:
Insert mounting plate between top motor and
arm. Make sure motor cables protrude in the
direction of the end of the arm.
Fasten motor and plate to arm using two 6 mm
steel bolts by accessing through the two large
holes in the bottom of the arm. Repeat for all
three arms.
Secure mounting plates together:
Place mounting plates with bottom motors
attached on underside of arm so that the three
outer holes in the plates align. Insert a 19 mm
hollow spacer between top and bottom holes;
thread a 25 mm bolt through spacer and plates.
Secure with a metal nut. Repeat for all three
holes on mounting plates. Repeat for all three
arms.
6-position to
5-position GPS
cable
4-position compass
cable
goo.gl/bM3MA.
Bottom motor assembly
Attach
motor
here
2