Diversitronics 5000-DMX Installations- und Betriebsanleitung - Seite 2
Blättern Sie online oder laden Sie pdf Installations- und Betriebsanleitung für DJ-Ausrüstung Diversitronics 5000-DMX herunter. Diversitronics 5000-DMX 3 Seiten. Linear strobe
Seite drucken5000-DMX Linear Strobe
Analog inputs have corresponding feed through outputs allowing daisy-chaining of control
lines.
Use DMX-512 standard cables when operating DMX (not supplied). For best results use 120
ohm end of line terminator (not supplied).
Modular pigtails are provided (two per fixture) to facilitate connecting to analog connectors. Pin
and color code assignments are as follows:
Yellow= Pin 1= Intensity control
Green= Pin 2 = Speed Control
Red = Pin 3 = +12 Volt (25ma) source
Black = Pin 4 = Circuit Common
DMX connectors should follow DMX standard pin assignments as follows:
Pin 1 = Signal common (shield)
Pin 2 = Data -
Pin 3 = Data +
Setting the DIP switch
The DIP switch selects the DMX channel that controls strobe intensity. Speed will
automatically respond to the next channel. For example setting the DIP switch to 11 (Switch
8,2, and 1 = on) will make DMX channel 11 intensity and channel 12 speed. When DIP switch
is set to zero (all off) the fixture will only respond to analog input.
LED Indicators
The Green (power) LED lights when main power is On.
The Red (DMX) LED lights when a DMX signal is present.
The Red (Temp) LED lights when a temperature overload exists, this LED also blinks in sync
to the flash signal and can warn of possible lamp failure if it is blinking but the strobe is not
flashing.
TOP OF PAGE
Single Flash Operation
When speed channel is zero any non-zero change of the intensity channel will cause one flash
to occur at that intensity value.
Hyperflash Operation
Controlled by the speed channel only, the intensity channel must be set to zero.
Nominal Speed Input
90%
http://www.diversitronics.com/catalog/tech_sheets/tech009.html
Hyperflash Mode
Hyperblast
Recycle Time
1 sec
3/12/08 12:54 PM
Page 2 of 3