ESE HD-266/SD Handbuch für Betrieb und Wartung - Seite 5

Blättern Sie online oder laden Sie pdf Handbuch für Betrieb und Wartung für Industrielle Ausrüstung ESE HD-266/SD herunter. ESE HD-266/SD 13 Seiten. Hd/sd sdi time code reader/inserter

Seite drucken

Four pushbuttons are supplied on the front panel. The Left and Right pushbuttons are used to

navigate through the menus. The Up and Down pushbuttons are used to select the menu

items available with each menu.

4.2 Rear Panel

4.2.1

Power Module

The power module on the rear panel accepts an IEC 320 three-wire line cord. A 2-amp fuse is

also part of the power module. The line cord must be removed in order to access the fuse.

4.2.2

ESE Input

The ESE Input BNC accepts ESE time code, ESE timer code or SMPTE/EBU LTC time code.

4.2.3

SDI Input

The HD/SD SDI Input is accessible on a rear panel BNC.

4.2.4

SDI Outputs

Two identical HD/SD SDI outputs are provided on rear panel BNCs. One device may be

connected to each output. The output format is the same as the input format.

4.3 Video Insertion

4.3.1

Two Windows

The date and time, the date, the time or up to 30 characters of text can be superimposed onto

the video in two independent windows. The 30 characters of text can be superimposed onto

either or both windows. Both windows can be blanked if desired.

4.3.2

Fonts and Colors

Ten different font sizes are available. Grayscale and six solid color fonts (red, orange, yellow,

green, blue and violet) are included.

5.0 SETUP

The LCD and pushbuttons allow the user to set up the features of the HD-266/SD without using the Control Panel

software. The menus are traversed using the left and right arrow buttons. The user can browse the options

available for each menu by using the up and down pushbuttons. The last selection made when exiting a menu is

selected.

Important Note: When the user stops on a selection by using the up and down arrow buttons and moves on to

the next menu, that item is selected. If no buttons are pressed for 30 seconds while navigating the menus, the

current item is selected and the display reverts back to the time and date. If the settings are changed via the

menu or Control Panel software, they are not made permanent for 30 seconds. Because of this, the unit should

not be turned off for 30 seconds after changes are made to the settings.

The default LCD display shows the time and date. Characters before the time and date indicate what is displayed.

An example is shown below.

RTC

12:34:44

2012/01/01

This example displays the real time clock (RTC) time 12:34:44 and date 2012/01/01 (Y/M/D). The "G" indicates

valid time code whereas an "E" indicates erroneous or no time code.

5.1 MENU SELECTIONS

The listings below show the menu title in bold followed by the selections available for that menu title along

with a description of each selection.

READ MODE:

ESE – The unit reads ESE time code via the rear panel BNC.

DVITC – The unit reads embedded DVITC time code.

RP188 – The unit reads embedded RP188 time code.

LTC – The unit reads SMPTE/EBU LTC time code via the rear panel BNC.

SMPTE DATE CODE:

309M DATE – The date format in the SMPTE/EBU time code is in SMPTE 309M format.

FMT-E DATE – The date format in the SMPTE/EBU time code is in the following format: XX-MM-DD-

YY.

Page 2

Revision 1.2