Clearbox nControl Benutzerhandbuch - Seite 4

Blättern Sie online oder laden Sie pdf Benutzerhandbuch für Werkzeuge Clearbox nControl herunter. Clearbox nControl 6 Seiten. Configuration tool

4. Using nControl Configuration Tool

The machine with the nControl Configuration Tool GUI installed must be connected to eth0 on an

nControl unit.

When the configuration tool is run the main window appears as seen in Figure 2. This window

consists of a menu bar, a table which will contain entries of each of the nControl units discovered,

and two buttons to refresh the table and to configure a selected unit.

The following process should be used for discovery of nControl units.

1) Select the correct interface from the "Interfaces" menu (Figure 3). This will be the

computer's built in network controller.

This is important if there are other interfaces installed due to VPNs or Virtual Machines.

2) Click "Refresh Devices" and table will populate with discovered nControl units. The visible

information will be Hostname, IP Address and Serial Number (Figure 4).

If no units are discovered either the wrong interface is selected or there are no nControl

units connected.

Units that are configured with DHCP will be discovered even if they have been unable to

obtain an IP Address. If a unit has not obtained an IP address, that field will appear blank in

the table.

Clearbox Systems Pty. Ltd. |Commercial In Confidence

nControl Configuration Tool User Manual

Clearbox Work Instruction

Figure 2: nControl Configuration Tool - main window

Revision: 0.1

4/ 6