Divine Acoustics PROXIMA Benutzerhandbuch - Seite 3

Blättern Sie online oder laden Sie pdf Benutzerhandbuch für Redner Divine Acoustics PROXIMA herunter. Divine Acoustics PROXIMA 8 Seiten.

Seite drucken

1. Before use:

CAUTION!

Never place the speaker vertically without well-tighten speaker plinth!

After unpacking, lay the speaker on its back on soft basis (carpet). Then attach the speaker plinth to

the bottom of speaker with use four screws. Also screw in the spikes into the speaker base. Spikes will

help speakers to maintain stability. Now speakers are prepared to place them vertically.

CAUTION!

Left speaker fits only to left plinth, right speaker fits only to right plinth.

Look at the labels located on the back of plinths.

2. Connecting:

Gold platted terminals accept a variety of cable terminations to suit most applications: banana

plugs, spades (bare wires up to 4mm in diameter). All connections should be made with amplifier

switched off.

CAUTION!

Before switching on the amplifier, make sure all connections are made properly

and volume control knob in the amplifier is set close to minimum.

CAUTION!

Speakers are capable of creating very loud sound pressures. NEVER set the

volume control knob in the amplifier to maximum.

- Solid state (transistor) amplifiers:

Red (positive) clamp of the speaker should be connected to amplifier output marked with (+).

Black (negative) clamp of the speaker should be connected to amplifier output marked with (-).

Incorrect connecting to the amplifier will cause improper sound of speakers and also may lead to

damage of equipment.

- Tube amplifiers:

Red (positive) clamp of the speaker should be connected to amplifier output (output

transformer) marked with „8 ohms".

Black (negative) clamp of the speaker should be connected to amplifier output marked

with (-) or (ground).

Incorrect connecting to the amplifier (example connecting to „4 ohms" output) may cause

improper equipment work, loss of sound details and may also lead to amplifier damage.

Several different kinds of speaker wires should be tested to achieve best sound performance.

3. Burning-in of speakers:

Before speakers will achieve its best performance a time of burning-in is needed (depending on

amplifier type from several days to even a few weeks). During that time coils, suspensions of drivers

and crossover parts will optimize and also adapt to the amplifier.

After that time, sound of the speakers should be smoother and more natural. Speakers will also

need a few burn-in hours after longer non-operating period or connecting to another amplifier.

4. Maintenance:

Speakers should not be exposed to direct excessive sunlight, high temperatures, excessive

moisture, and high dustiness of environment.

For maintenance of cabinet surfaces (dusting) use only soft clothes. Furniture and leather

aerosol cleaners can be used. Spray onto the cleaning cloth, not directly onto the cabinet.

Diaphragms of transducers can be cleaned only by using air movement (without any liquids):

blowing or delicate vacuum cleaner. Please avoid touching diaphragms.

Under pain of warranty nullity replacing of transducers or making construction changes is

forbidden.

PROXIMA

OWNER'S MANUAL