esera 12002 Konfiguration

Blättern Sie online oder laden Sie pdf Konfiguration für Aufnahmegeräte esera 12002 herunter. esera 12002 7 Seiten.

Art. No. 12002

Configuration of the Ethernet interface for TCP and UDP operation

INTRODUCTION

In order to commission or configure the eBus coupler under Windows® , the installation of the "Configuration-

Tool" (hereafter called Config-Tool) is necessary.

This manual describes the installation of the "Configuration Tool" (hereafter called Config Tool) and configuration

of the Ethernet interface under Windows 7®.

Execute the installation with administrator rights.

This manual is applicable for the following versions of the eBus coupler:

Art. No. 12002 eBus coupler Ethernet

Note

Before you start assembling the device and put it into operation, read this manual carefully to the end,

especially the section on safety instructions.

PREPARATION, COMPARISON eBus

After connecting the eBus coupler with the power supply and a network cable to a PC, the power LED on the top

of the device lights up and signals that the device is ready for operation.

For details on adjusting the eBus level, please refer to the current operating instructions for the device

CONNECTION

2.1

eBus connection

(module top side)

7 = not used

8 = Trimmer for response point

9 = Not assigned

10 = LED display for eBus

11 = eBus

12 = eBus

Power supply connection

(module underside)

1 = minus

2 = Plus

3 - 6 = not used

Subject to technical changes.  ESERA GmbH 2023

www.esera.de

Configuration

eBus coupler Ethernet

12002 V2.0 R1.1 configuration ETH

Page 1 from 7