3DUpFitters Ender 5 Plus R1 Enclosure Kit Installationshandbuch - Seite 11

Blättern Sie online oder laden Sie pdf Installationshandbuch für 3D-Drucker 3DUpFitters Ender 5 Plus R1 Enclosure Kit herunter. 3DUpFitters Ender 5 Plus R1 Enclosure Kit 18 Seiten.

Seite drucken

3. Back Panel

The back of the enclosure will be a little more

complicated since it contains a door. Start by

attaching the back panel to the front and left-side

panels. The four corner connectors are mirror

images of the front. The large hole is either for the

fan, the option of an air ﬁlter (purchased

separately), or completely covered up by printing a

cover on Thingiverse. On each side are "mid-panel

corner connectors."

Next, assemble the back door using the same

techniques as the front door, i.e., hinges, latch

mounts, and strike plates. The main diﬀerence is

that the strike plates will need to be squeezed in to

ﬁt the smaller thickness of the back panel v.s. The

front panel.

Finally, attach the fan conﬁrming the direction of the

fan's air ﬁlter to pull air OUT of the enclosure. The

illustration to the right shows the fan attached to the

optional charcoal ﬁlter. Attach using M4 cap head

30mm or 40mm screws depending on the depth of the

particular fan.