ESI EPPA2-KIT Anleitung Handbuch - Seite 7
Blättern Sie online oder laden Sie pdf Anleitung Handbuch für Racks & Ständer ESI EPPA2-KIT herunter. ESI EPPA2-KIT 12 Seiten. Dual monitor arm conversion
Seite drucken
DUAL ARM BASE ASSEMBLY INSTALLATION
Base Assembly Attachment Methods
Typically, you will use the same method to attach
the dual arm base that was used to attach the
single arm base.
• Clamp method. The base assembly is clamped to
a table or desk surface that is between
thick and 3
/
" (85mm) thick. See below.
1
4
• Grommet method. The base assembly is secured
through a grommet hole in the worksurface.
Surface thickness must be between
and 3
/
" (85mm). See page 8.
1
4
Clamp Method
With the clamp method, the clamp L-bracket, clamp, and clamp pad are assembled to the base.
1. Attach the clamp L-bracket to the underside of
the base. Use the three M6x12 flat head screws
and the 4mm Allen key.
2. Peel the adhesive backing from the clamp pad
and attach the pad to the base and L-bracket.
3. Attach the clamp to the clamp L-bracket using
the two M6x10 socket cap screws and the
5mm Allen key. Then snap the plastic cap onto
the back of the L-bracket.
A. Attach the clamp to the top two holes if the
thickness of the worksurface is between
(10mm) and 2
/
1
8
B. Attach the clamp to the bottom two holes if
the thickness of the worksurface is between
2
/
" (55mm)and 3
1
8
Install Base Assembly
• Clamp the base assembly to the worksurface in the desired position. Be sure to tighten the knob securely.
• Proceed to "Monitor Installation" on page 9.
/
" (10mm)
3
8
/
" (10mm)
3
8
" (55mm).
/
" (85mm).
1
4
1.
M6x12
Flat Head
3A.
/
"
3
8
Plastic
Cap
Clamp
Method
2.
4mm
Allen Key
5mm
3B.
Allen
Key
Plastic
Cap
M6x10
Socket Cap
EPPA2-KIT
Grommet
Method
Clamp Pad
7