ESI 2TD-C48-30-SLV Montageanleitung Handbuch - Seite 9
Blättern Sie online oder laden Sie pdf Montageanleitung Handbuch für Inneneinrichtung ESI 2TD-C48-30-SLV herunter. ESI 2TD-C48-30-SLV 12 Seiten.
Seite drucken
Trada 2-leg
Step #13: initialize the table and test operation
• Press the DOWN t button to move the legs to their lowest position. This initializes
the table and makes it ready for operation.
• Test operation by pressing the UP s and DOWN t buttons individually to move the
legs to their fully extended and fully compressed positions.
— End your test with the legs lowered.
— Unplug the power cord.
• If there is a problem with operation, check that all cable and cord connections are
secure. Check to be sure the AC outlet has power. If problems continue, call ESI
Customer Service: 800.833.3746.
NOTICE: With the table upside-down, the DOWN t button points up and the
UP s button points down.
Step #14: use cord clips to secure cables and cords
CAUTION: The cables and cords must not dangle under the table where they may present
a hazard to the user or may accidentally be pulled from their connections.
• Place the cord clips onto the cables and cords.
• Use the #6x
/
" Phillips round head screws to fasten the cord clips to the table.
5
8
Step #15: turn the table upright
WARNING: Lifting hazard. Single person lift could cause injury. Use assistance when moving or lifting.
• With the assistance of a helper, turn the table upright and place it in its final position. IMPORTANT: There must be 1.0" (25mm) of clearance on all sides of the
worksurface (and other moving parts) to ensure free, unobstructed movement.
• If necessary, adjust the leveling glides on the feet to level the worksurface.
• Plug the power cord into an AC outlet.
• Press the DOWN t button to move the table to its lowest position. IMPORTANT: Be sure there are no obstacles under the table that would prevent it from reaching its
lowest position.
• See the following pages for operating procedures.
NOTICE: Whenever the unit is unplugged or the power is cut, the table must be re-initialized by pressing the DOWN t button to move the table to its
lowest position.
DOWN t
button
round head
cord clip
Page 9
UP s
button
(handset is upside-down)
press DOWN t button
to lower legs
#6x
/
"
5
8
Phillips
Assembly