Akiyama DX-303 Gebrauchsanweisung - Seite 4

Blättern Sie online oder laden Sie pdf Gebrauchsanweisung für Drehscheibe Akiyama DX-303 herunter. Akiyama DX-303 11 Seiten.

Seite drucken

d x t u r n t a b l e s

1) START/STOP

Press this button to start or stop the platter.

2) PLATTER

3) MOTOR OFF

Press the button to enable motor off, and the led will be flash

Press the button again to disable function.

4) TARGET LIGHT

Insert target light to the deck and it will light up.

5) PLATTER REVOLUTION SPEED BUTTONS

33 rpm press 33

45 rpm press 45

78 rpm press 33 and 45

6) REVERSE

This button is used to reverse the direction of the platter rotation.

7) +/-8%,+/-12%,+/-20%

Press the button to switch to 8%, press again to switch to 12%, and

again to 20%.

8) QUARTZ LOCK

On will hold the revolution speed to 0%.

Off will allow use of the pitch adjust.

9) HEADSHELL LOCKING NUT

Attach the headshell by inserting into the front end of the tone arm,

then turn the locking nut clockwise with the head shell firmly held

horizontally.

10) PITCH SLIDER

PART NAMES AND FUNCTIONS

dx turntables

Use this to change the speed of the platter when the PITCH indicator

is NOT lit.

11) TONE ARM

This is a fully manual tone arm. To start playback, gently place the

stylus on the record using the headshell finger support. Do not drop

the stylus onto the record as it may cause damage to the diamond

tip and to the record.

12) 45 RPM ADAPTOR

Place on centre spindle fo

r playing 7" r

13) ANTI SKATE KNOB

When a record is playing, a force is generated drawing the stylus

towards the centre of the record. Set this knob to the same value as the

stylus pressure to offset this force.

14) COUNTER WEIGHT

Use this to balance the tone arm and to adjust the stylus pressure.

15) POWER SWITCH

This switch turns the power on or off, including the motor and audio

signal.

16) POWER CORD CONNECTOR

Used to connect the included power cord.

17) OUTPUT SIGNAL SELECTOR

Two forms of output audio signal are available: Phono and Line.

18) AUDIO OUTPUT CONNECTOR

This is the audio output connector (RCA). Must be connected as

explained at Connections part of this manual.

ecords with large centre holes.