Altocraft 68125136 Benutzerhandbuch - Seite 20

Blättern Sie online oder laden Sie pdf Benutzerhandbuch für Bohrer Altocraft 68125136 herunter. Altocraft 68125136 20 Seiten. 18v cordless drill / driver

Seite drucken
OPERATION
KEYLESS CHUCK
1.
Center the rotation direction knob to prevent the motor accidentally starting.
2.
Note there are two rings on the chuck.
chuck tightening ring of the chuck (
by hand while with the other hand, holding the second chuck stop ring (B in
the functional description) to prevent the motor turning; this closes the jaws
of the chuck.
3.
Turning that same chuck tightening ring counter-clockwise opens the jaws.
Open the jaws to insert a bit and then close the jaws so they clamp the bit
tightly.
MAINTENANCE
Keep the tool clean using a soft damp (not wet) cloth. Do not use solvents on
1.
the plastic parts.
Lubrication is not necessary. After long use, have an authorized service centre
2.
maintain and lubricate the tool.
Should the chuck require replacement,
3.
Remove the battery pack
Open the chuck jaws as widely as possible so you can get at the chuck
retaining screw.
Unscrew the chuck retaining screw with a Philips screwdriver. Note that
this is a left hand threaded screw and you remove it by turning it clockwise.
Clamp the shorter arm of a large Allen wrench in the chuck, aligning it with
the jaws so they grip three of its six flat sides.
Place the drill on a flat surface, and support the chuck with a piece of wood
about 3/8" (10 mm) above that surface. Or press the drill body on the working
table and make the chuck hanging in the air. (Be careful with your hand!)
Strike the long arm of the wrench with a hammer so that the chuck turns
counter-clockwise and unscrews from the spindle. This may require a fairly
sharp blow.
Repeat the process in reverse to install a new chuck.
4. To maintain the best performance of your rechargeable Ni-Cd battery, protect
it from overheating, both from overcharging and during storage. Occasionally
charge the battery for 7 hours. The battery may also benefit from a full
discharge from time to time.
WARRANTY
Thank you for investing in a ALTOCRAFT power tool. These products have
been made to quality standards and are guaranteed for domestic use against
manufacturing faults for a period of 12 months from the date of purchase.
This guarantee does not affect your statutory rights. In case of any
malfunction of your tool (failure, missing part, etc.), please contact one of our
service technicians at our toll free service line at 1-866-206-0888 from 8 AM
to 6 PM, Monday to Friday, Eastern time. RONA reserves the right to repair or
replace the defective tool, at its discretion.
The product is guaranteed for 12 months if used for normal trade purposes.
Any guarantee is invalid if the product has been overloaded or subject to
neglect, improper use or an attempted repair other than by an authorized
agent. Heavy-duty, daily professional or hire usage are not guaranteed. Due
to continuous product improvement, we reserve the right to change the
product specification without prior notice.
20
CD302
Turning the endmost knurled ring, the
A in the functional description) clockwise