Edgewater Networks 4610W Schnellstart-Handbuch - Seite 3
Blättern Sie online oder laden Sie pdf Schnellstart-Handbuch für Gateway Edgewater Networks 4610W herunter. Edgewater Networks 4610W 7 Seiten. Network services gateway
Seite drucken
Step 1 ! Connecting the Cables
1. Connect one end of an Ethernet cable to local LAN port 24 of the 4610W device. This
port can be seen in the area "C" of the above diagram. Connect the other end of the
cable to your computer's Ethernet port.
2. If T1 is used for the WAN connectivity then perform the following steps, otherwise go to
step 5.
3. Based on the number of functional ports, connect on end of the T1 cable(s) to the T1
port(s) and the other end of the cable(s) to the T1 demarcation unit provided by the
Service Provider. The T1 port(s) are located in area "E" of Figure 1.
To reduce the risk of fire, connect the T1 port to the T1 network using only 26
AWG or larger wire such as 24, 22, 20, etc.
4. Skip to step 6.
5. Connect an Ethernet cable between the Ethernet WAN port of the 4610W device, shown
in the above diagram as "D," and the Ethernet port on a router or a modem.
6. Connect the PSTN lines to ports denoted by "F" or "G" in the above diagram.
7. Connect the regular phones or key system to ports denoted by "G" in the above diagram.
Figure 1: 4610W Front Panel
Instructions
Page 3 of 7