Edgewater Networks EdgeMarc 4552 Schnellstart-Handbuch - Seite 3
Blättern Sie online oder laden Sie pdf Schnellstart-Handbuch für Gateway Edgewater Networks EdgeMarc 4552 herunter. Edgewater Networks EdgeMarc 4552 7 Seiten. Networking gateway
Seite druckenStep 1
Connecting the Cables
1. Connect one end of an Ethernet cable to local LAN port 1 of the 4552. This port can be
seen in the area "B" of the above picture. Connect the other end of the cable to your
computer's Ethernet port.
2. If T1 is used for the WAN connectivity then perform the following steps, otherwise go to
step 5.
3. Based on the number of functional ports, connect on end of the T1 cable(s) to the T1
port(s), located in area "D" of the above picture, and the other end of the cable(s) to the
T1 demarcation unit provided by the Service Provider.
To reduce the risk of fire, connect the T1 port to the T1 network using only 26
AWG or larger wire such as 24, 22, 20, etc.
4. Skip to step 6.
5. Connect an Ethernet cable between the Ethernet WAN port of the 4552, shown in the
above diagram as "C," and the Ethernet port on a router or a modem.
6. Plug one end of the power adapter into an AC outlet and the other end into the power
receptacle on the 4552.
Make sure that the power and status LEDs, shown in the diagram below as "A" and "B",
are solid green after a short while.
Instructions
Page 3 of 7