Edgewater Networks EdgeMarc 5300LF Hardware-Installationshandbuch - Seite 14
Blättern Sie online oder laden Sie pdf Hardware-Installationshandbuch für Netzwerk-Router Edgewater Networks EdgeMarc 5300LF herunter. Edgewater Networks EdgeMarc 5300LF 20 Seiten.
Auch für Edgewater Networks EdgeMarc 5300LF: Schnellstart-Handbuch (8 seiten)
Seite drucken5300LF Converged Network Appliance Installation Guide
5. Select Network and start configuring the 5300LF appliance.
Note
For secure network management on an EdgeMarc or EdgeProtect 5300LF appliance, change
the default user name and password as described in the VOS for EdgeMarc User Manual.
Configuring the EdgeView 5300LF
You can configure the 5300LF Edgeview appliance using YaST, a pre-installed, LINUX-based
system management tool. Access YaST from the command line interface of the EdgeView
appliance.
To connect to the 5300LF Edgeview appliance, follow these steps:
1. Connect a PC with a cross-over Ethernet cable to Port 1 of the EdgeView chassis.
2. Since Port 1 is 192.168.1.1, configure your PC to have the IP address of 192.168.1.2,
subnet mask of 255.255.255.0 and default gateway of 192.168.1.1.
3. Make sure you can ping 192.168.1.1 from your PC.
4. Open your favorite SSH application on your PC and SSH to the EdgeView. (Note: The new
LF chassis only accept SSH v2. In PuTTY, go to the SSH tab on the left and under Preferred
SSH Protocol Version, select 2)
5. Log into the CLI.
6. Type 'yast' at the # prompt. The configuration page appears as follows:
11