ClearView PowerBoards PB -TA-004 Installationsanleitung Handbuch - Seite 8

Blättern Sie online oder laden Sie pdf Installationsanleitung Handbuch für Zubehör für Kraftfahrzeuge ClearView PowerBoards PB -TA-004 herunter. ClearView PowerBoards PB -TA-004 16 Seiten. Toyota land cruiser 79 series 1984 - current

Seite drucken

Fitting Instructions

Step 2

Installation of control unit and wiring

2.1 Layout ECU and Wire Harness set in Passenger

footwell area.

Connect the Motor Wire harness (small white

power plug) and Sensor Wire harness (large white

plug) to ECU.

Once connectors are plugged in, leave ECU and

wiring set in Left-Hand floor area, and tidy up at

the end to ensure enough slack of wiring can be

fed throughout the vehicle.

2.2 Connect motor wires to corresponding connectors on

motor wire harness.

Passenger side wires are:

side wires are:

Red

Route RM (Right Middle) driver-side motor wire AND

R-LED connector under the vehicle dash and bring it

across to the driver-side footwell, then route both

through the rubber grommet in vehicle floor and

connect wire to the motor and LED connector on the

RM Bracket Assembly.

Route

Passenger

connector through the rubber grommet in vehicle

floor and connect wire to motor and LED connector

on the LM Bracket Assembly.

NB: Holes for routing can be found under floor

carpet/vinyl depending on vehicle variant.

Helpful tip when removing the rubber grommets, you

may either cut a single hole or a cross/+ pattern in

each grommet, sized to allow the plug on the wiring

looms to pass through.

Remember to place grommets back into floor panel of

vehicle and feed end of the Wiring Looms with small

plug through the hole in the grommet.

2.3 Connect the negative (black) wire from the motor wire

harness to an earth/ground point on the passenger side of the

chassis, near where you would mount the ECU.

Connect the

positive (red) wire

corresponding connector found on the motor wire harness.

Green

/ Yellow, and Driver

Blue

side

motor

wire

from Step 1.2 to the

clearviewaccessories.com.au

Connector for RM motor

and

L-LED

Passenger (left) side

motor wiring

Passenger (right)

side motor wiring

Connector for LED