Altrad Belle HDC 350 Benutzerhandbuch - Seite 13
Blättern Sie online oder laden Sie pdf Benutzerhandbuch für Kutter Altrad Belle HDC 350 herunter. Altrad Belle HDC 350 18 Seiten.
Seite drucken
Regular maintenance is a basic requirement for the continued safe and ef cient use of the machine.
Follow the maintenance instructions carefully.
•
Before starting maintenance on the machine, clean it in order to avoid exposure to hazardous substances. See "Dust and fume
hazards"
•
Use only authorised parts. Any damage or malfunction caused by the use of unauthorised parts is not covered by warranty or
product liability.
•
When cleaning mechanical parts with solvent, comply with appropriate health and safety regulations and ensure there is satisfactory
ventilation.
•
For major service of the machine, contact your nearest authorised workshop.
•
After each service, check that the machine's vibration level is normal. If not, contact your nearest authorised workshop.
Every Day
Before undertaking any maintenance on hydraulic machines, always switch off the oil supply and bleed the machine by depressing the
start and stop device Then disconnect the hydraulic hose from the machine.
•
Clean and inspect the machine and its functions each day before the work commences.
•
Check if the spindle thread, the guard (the disc may not touch the guard) and the ange are in good condition.
•
Conduct a general inspection for leaks, damage, and wear.
•
Change damaged parts immediately.
•
Replace worn components in good time.
•
Make sure that all the attached and related equipment, such as hoses and ow dividers are properly maintained.
•
If the machine has been dropped, carefully examine the disc.
•
Ensure that the disc dimensions are compatible and that it ts the spindle.
•
Always plug hoses and nipples with clean and tight plugs when dismounting.
•
Check tightness of nuts, bolts, screws and hose ttings after the rst days of operation and thereafter in accordance with the
maintenance schedule.
Every Three Months
•
Check tightness of nuts, bolts, screws and hose ttings.
Every 300 Hours of Operation or Every Year
•
Check moving parts, seals and bolts for wear and cracks. Replace if necessary.
•
Check the function of the machine.
Problem
Saw turns too fast or develops too
much torque.
Saw will not turn at all or turns too
slowly.
Saw does not develop enough
torque (insuf cient power to cut
material)
Check that the machine is properly cleaned before storage.
•
Store the machine in a dry place.
•
Keep the machine and tools in a safe place, out of the reach of children and locked up.
Maintenance
Troubleshooting Guide
Cause
Connected to improper power source.
Power source not adjusted correctly.
Power supply defect.
Valve block defect.
Motor defect.
Power supply defect.
Motor defect.
Storage
13
Remedy
Use proper power source.
Adjust power source ow and pressure set-
tings as per the manufacturer's instructions.
Disconnect saw and check power supply.
Repair or replace.
Disconnect power source and try to turn the
motor shaft by hand. Repair or replace.
Repair or replace.
Repair or replace.
GB
GB
GB