ArtFox ATMIC 3000 Benutzerhandbuch - Seite 2

Blättern Sie online oder laden Sie pdf Benutzerhandbuch für Spotlight ArtFox ATMIC 3000 herunter. ArtFox ATMIC 3000 7 Seiten.

Seite drucken
Safety Information
Warning：This product is tight for professionals to use, unauthorized use of non-professionals do
not, to avoid danger.
Prevention of electric shock
Replacing light bulbs, fuses or any other components, and it is not in use, disconnect the AC.
The power of the ground state will always maintain a good ground.
Use the power supply shall comply with the requirements of the standard specification and fitted
with overload protection devices and grounding facilities.
Do not let the light rain and was wet.
Replace the lamp must be installed to install required, or by the Company to replace the
professional technician.
When the shading of glass open, damaged or not, do not operate when the lamps.
Do not stare directly into the lamp, when the light bulb flashing when not to stare directly at
lights.
When the lamp aging or broken light bulbs need to be replaced in order to avoid outside.
Do not short circuit or fuse directly replace the defective fuse, you must first wife according to
the original manufacturer for replacement models and parameters.
Check whether the current rating of all power cables connected to the fixture.
Flammable materials (alcohol, gasoline, paper) from the lamp body for at least a distance of 0.5
meters, the lamp surface temperature to avoid ignition of other flammable materials.
Surface of the lamp close to the fire source within 1 meter.
And the exhaust fan and air vents to keep the distance about 0.1 meters.
Do not replace the parts do not belong to the company.
Light body temperature can reach 120 °, lamp cooling time after the operation at least 15
minutes.
Ambient temperature exceeds 40 ° C, do not operate with a strobe light.
To prevent you and other people were injured by falling lamps
When the device is suspended above the ground level when the test installation of at least 10
times
Check all the outside lid, light hook, rope, safety and other accessories are well prepared
Do not operate lights near the staircase
Strobe advance notice before use.
Avoid exceeding the period of continuous strobe, strobe frequency is 10-20 times / sec.
Power Connector
Provide automatic adjustment of any 50-60Hz AC, from 90 to 260 volts, no need for regulation,
attention XOP 15-OF lamps can not AC125V the following conditions.
ATMIC 3000 models to be under the lamp, power supply and use. To avoid overload, each
at least 16-20A lamp power, use the 2.5m square meters of cable.
Install a plug to the lamp power supply line, to facilitate the connection power supply;
Follow the color coded wiring cable lamps: