Altron TROVE Trove2HR2R Installationshandbuch - Seite 3
Blättern Sie online oder laden Sie pdf Installationshandbuch für Gehege Altron TROVE Trove2HR2R herunter. Altron TROVE Trove2HR2R 8 Seiten. Trove rack enclosure with altronix and identiv backplane
Seite druckenWiring methods shall be in accordance with the National Electrical Code/NFPA 70/ANSI, and with all local
codes and authorities having jurisdiction. These products are for indoor use only and must be installed within
the protected premises.
Note: First assemble and Install Z Bracket Wire Management Accesory
(refer to Z Bracket Installation pg. 4)
1. Remove backplane from enclosure prior to installing into rack cabinet
(do not discard hardware).
2. In order to mount included cUL Listed tamper switch (Tane Model 3/8 ASH FM WH
or equivalent) turn the enclosure upside down and locate mounting holes
(Fig. 1, pg. 3). Insert the tamper switch flying leads into the center knockout of
the three (3) holes from outside of thedrawer with the button facing outwards,
make sure tamper switch is inserted properly then secure it with the two (2)
screws (supplied). Connect tamper switch wiring to the Access Control Panel
input or the appropriate UL Listed reporting device.
To activate alarm signal open the rack drawer.
3. Slide the rack enclosure into an open 2U location in the four post rack cabinet.
4. Utilizing proper fasteners attach front ears to the rack rails (Rack drawer, pg. 8).
5. Attach the rear of the adjustable slides to the rear rails of the rack cabinet with the proper fasteners.
6. Secure the rack cover (Fig. 2a, pg. 3) and rack drawer (Fig. 2b, pg. 3) to earth ground.
7. Ensure that all internal cofigurations (voltage selection, switch settings, etc.) are completed before
mounting backplane back into Trove rack enclosure.
Fig. 2
Fig. 2b
Trove2HR2R Installation Guide
Installing Trove2R into Rack Tower:
Fig. 1
Back of the drawer,
viewed from outside.
Tamper Switch
mounting location
Fig. 2a
- 3 -