dji Phantom 4 Pro V2.0 Schnellstart-Handbuch - Seite 8
Blättern Sie online oder laden Sie pdf Schnellstart-Handbuch für Drohnen dji Phantom 4 Pro V2.0 herunter. dji Phantom 4 Pro V2.0 10 Seiten.
Seite druckenCompliance Information
FCC Compliance Notice
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and (2) This device must accept any interference
received, including interference that may cause undesired operation.
Any changes or modifications not expressly approved by the party responsible for compliance could void
the use 's autho ity to ope ate the e uip e t.
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant
to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses and can radiate radio frequency
energy and, if not installed and used in accordance with the instructions, may cause harmful interference
to radio communications. However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or television reception, which can
be determined by turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
—Reorient or relocate the receiving antenna.
—Increase the separation between the equipment and receiver.
—Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
—Consult the dealer or an experienced radio/TV technician for help.
ISEDC RSS Warning
This device complies with licence -exempt RSS standard (s). Operation is subject to the
following two conditions: (1) this device may not cause interference, and (2) this device must accept any
interference, including interference that may cause undesired operation of the device.
Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux appareils radio exempts de
licence.
L'exploitation est autorisée aux deux conditions suivantes:
(1) l'appareil ne doit pas produire de brouillage, et
(2) l'utilisateur de l'appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est
susceptible d'en compromettre le fonctionnement.
RF Exposure Information
Aircraft complies with FCC/ISEDC
order to avoid the possibility of exceeding the FCC/ISEDC radio frequency exposure limits, human
proximity to the antenna shall not be less than 20cm during normal operation.
For Remote Controller (model GL300L),
positions accepted by the FCC/
level in
all tested frequency bands, although the SAR is determined at the highest certified power level,
the actual SAR level of the
Before a new model is a available for sale to the public, it must be tested and certified to
that it does not exceed the exposure limit established by the FCC
in positions and locations
radiation exposure limits set forth for an uncontrolled environment. In
SAR tests are conducted using standard operating
with the
remote controller
ISEDC
remote controller
while operating can be well below the maximum value
required by the FCC
as
transmitting at its highest certified power
Tests for each
/ISEDC,
/ISEDC.
value.
/ ISEDC
the FCC
are performed
model