dji Aeroscope Mobile Benutzerhandbuch - Seite 6

Blättern Sie online oder laden Sie pdf Benutzerhandbuch für Drohne & Quadcopter Zubehör dji Aeroscope Mobile herunter. dji Aeroscope Mobile 7 Seiten. Stationary unit installation
Auch für dji Aeroscope Mobile: Benutzerhandbuch (15 seiten)

Seite drucken

4. Often, the supplied power cable is too short for the connection between the stationary unit

and the nearest available power outlet. In such cases, a qualified electrical engineer must

extend the initial power cable to complete the connection.

5. After powering on, check the LED indicators with reference to Figure 7.

LED1

LED2

LED3

Figure 7. LED explanations

6. Download DJI Assistant 2.

from https://www.dji.com/aeroscope/info#downloads

7. Install and run DJI Assistant 2 on a windowns computer (desktop or laptop).

8. Connect the computer and the Aeroscope unit to the same router, or connect them directly

via the Ethernet port.

9. After the Aeroscope stationary unit is found on the DJI Assistant 2 start page, set the

server IP and Port in Network Settings>Server Network Settings.

10. Set the network mode to Wireless if using a wireless dongle. Set to Wired if using an

Ethernet connection. Depending on network provider requirements, set the parameters

manually or set the mode to Auto.

11. Exit DJI Assistant 2.

12. Restart the stationary unit.

13. Connect the stationary unit to the internet.

a. It is recommended to always use Ethernet when possible, because the connection is

stable and free of interference.

b. If using a wireless connection, the dongle must be installed with an active SIM card.

You may need to configure some parameters such as APN in DJI Assistant 2.

14. Log into the Aeroscope web server https://Aeroscope.djiservice.org using your assigned

account. The account management system in Aeroscope manages the relations between

each account and each Aeroscope unit. Make sure the DJI admin has added your unit to

your account. Otherwise, you will not see your unit when you log in.

Importing Certificates

In most cases, when you receive your Aeroscope stationary unit the certificate should already

be imported. If the certificate doesn't work or has expired, you will need to import a new

LED4

LED5

LED6

Aeroscope Stationary Unit Installation

LED1: Processor module status

LED2: Network connection status

LED3: UAV information capture status

LED4: Type 3 receiver status

LED5: Type 2 receiver status

LED6: Type 1 receiver status