AIMS Power SCC11ARPM Schnellstart-Handbuch - Seite 2
Blättern Sie online oder laden Sie pdf Schnellstart-Handbuch für Controller AIMS Power SCC11ARPM herunter. AIMS Power SCC11ARPM 2 Seiten. Solar charge controller
Seite drucken
Status LED Indications
LED Indications
Status
Off
Steady On
Solar
Charge
Slow Flash
Indicator
Quick Flashing
Off
Battery
Steady On
Status
Indicator
Quick Flashing
Recommendations During Use
The controller generates heat during operation. AIMS Power
recommends installing the charge controller in an
environment with good ventilation.
Check your connections often. Make sure wires and MC4
connectors are in good condition and securely connected.
Charge controller is waterproof. Ensure wire is also
waterproof.
It is important to fully charge the battery at least one full
charge every month. Failure to do so may cause permanent
damage to the battery. When charging the battery, make sure
the load on the battery is lower than the charge rate so the
battery gets a full charge. Incorporating a voltage meter into
your system is recommended.
If you don't need to extend the battery cable, simply cut off
the MC4 connectors and connect battery lugs. Not the
polarity. Do NOT reverse. This will void the warranty.
Functions
Solar panel has no voltage
Solar panel has voltage
Charging
System over voltage
Battery is not connected
Battery on
Battery is over-discharged
Specifications
SCC11ARPM
Battery System Voltage
Max System Current
No-Load Loss
Max PV Input Voltage
Max PV Input Power
Equalize Charge Voltage
Boost Charge Voltage
Float Charge Voltage
Boost Charge Recovery Voltage
Over-discharge Recovery Voltage
Over-Discharge Voltage
Equalize Charge Duration
Boost Charge Duration
Operation Temperature
IP Protection - Waterproof
UPC
VALUE
12V
11A
8mA
< 30Voc
190W
NA
14.2V
13.8V
13.2V
12.6V
11.1V
NA
2 Hours
-31°F to 140°F / -35°C to 60°C
IP68
840271005966