djm direct 01985-V2 Original-Bedienungsanleitung - Seite 9

Blättern Sie online oder laden Sie pdf Original-Bedienungsanleitung für Säge djm direct 01985-V2 herunter. djm direct 01985-V2 17 Seiten.

Adjusting the riving knife

Ensure that the mounting blocks projecting lugs engage with the slot

in the riving knife. Adjust the riving knife so that it is between 3-5mm

from the saw blade. The blade guard mounting hole on the riving

knife should be at least 10 mm higher than the tooth peak.

Blade guard and Dust extraction port adaptor

When correct alignment is achieved tighten the fixing bolt. Check the

saw blade rotates freely and teeth are within 3-5mm of the riving

knife. Re-install the table access plate. The guards locating pin should

be positioned through the hole machined in the top edge of the

riving knife. Secure using the thumb screw, do not over tighten. crew,

do not over tighten.

Note: Adjust the blade guard for the material you are cutting. To

adjust to the thickness of the material being cut, the blade guard

must pivot up and down easily and smoothly, so do not over-tighten

this wing nut.

Check the operation of the blade guard. Ensure that it is working

efficiently and covers the blade at the sides as well as the crown.

Lower the blade a little and recheck that the blade guard operation.

When satisfied that the blade guard works throughout the blades

height adjustment range, check that the guard works equally well

with the blade set to a bevel angle.

Check that when the blade is fully lowered, the blade guard is in

contact with the table top.

Note: The top blade guard is equipped with a dust extraction port .

Connect the supplied dust extraction hose to the top blade

guard. The hose is a 'push fit' onto the extraction port.

Connect the other end of the hose to the 2 way connector found to

the rear of the machines main body.

Note: The 'free' port of the 2 way connector can be used to attach a

workshop dust extraction machine to this Evolution machine. If such

a machine is connected to this Table Saw follow the Instructions

provided by the supplier/manufacturer of the dust extraction

equipment.

Use of such equipment will ensure that the workplace is kept clean

and tidy, and that dust is kept to a minimum.

Saw blade

1.Make sure that the inner flange washer(the inner washer has a

round hole in the centre) is placed on the drive shaft.

2. Place the saw blade onto the flange of the support washer. Make

sure that the saw blade is facing the right way. The direction of

rotation markings on the blade should be facing outwards and

correspond with the markings on the saw.