djm direct DJMBD13-40 Original Betriebsanleitung - Seite 9

Blättern Sie online oder laden Sie pdf Original Betriebsanleitung für Bohrer djm direct DJMBD13-40 herunter. djm direct DJMBD13-40 19 Seiten. Bench drill

Seite drucken

8. Set Up

Place the drill press on a solid flat surface. Ideally, bolt

the drill press to the surface. Use the two holes in the

baseplate for this.

Selecting the Speed

1. Release the locking screw on the gear cover with

the allen key 5 mm.

2. Pull the locking screw and open the gear cover.

3. Unfasten the thin nut M8 enough and release the

clamping screw with an allen key 6mm(not scope of

delivery) on the motor. See below illustration 1.

4. Slide the motor forward a little to release the

load on the V-belts. See below illustration 2.

5. Remove the V-belt between idle pulley and

motor pulley first, then slide idle pulley towards

the spindle pulley to release the load on the V-belt

between idle pulley and spindle pulley. Remove

the second V-belt. See below illustration 2 & 3.

6. Place the two V-belts on the desired assembly

to reach the specified speed.

7. Slide the motor back to tension the V-belts

again. The V-belts are correctly tensioned when

it gives way slightly when pressed. Deflection

distance of belt is 5-10mm.

8. Tighten the clamping screw with an allen key 6

mm (not scope of delivery) on the motor again.

9. Close the gear cover. Fasten the locking screw

on the gear cover with the allen key 5 mm.

The gear cover is equipped with a

interlock switch. If the gear cover

is not closed correctly, the device

cannot be switched on.