Cleerline SSF Schnellstart-Handbuch

Blättern Sie online oder laden Sie pdf Schnellstart-Handbuch für Netzwerkkabel Cleerline SSF herunter. Cleerline SSF 2 Seiten. 3.0 mm breakout kit

Seite drucken

Cleerline SSF

This guide describes spider breakout kit installation on 250 µm optical fiber. Installation factors such as available cable slack,

location of the termination hardware and the question of build tube slack storage as opposed to cable slack can dictate when and

where you choose to mount the cable end and assemble your breakout kit.

1. Slide included and grommet strain relief boot

onto cable.

4. Working on a flat surface with an edge, tape

down the cable.

CLEERLINE

TECHNOLOGY GROUP

3.0 mm Breakout Kit

Each Breakout Kit Contains

a. Insert block furcation tube assembly

(1 for 6 fiber, 2 for 12 fiber)

b. Outer Shell

c. Housing

d. Grommet Strain Relief Boot

e. Nut

f. Screw (x2)

g. Plug (not used in these instructions)

h. 6 Fiber Bushing (not used in these instructions)

i. 12 fiber Bushing (not used in these instructions)

2. Measure the tubing down the length of the

cable. Place a mark 6"/15 cm from the end of

the tubing.

5. Separate aramid yarns from fiber. Cut yarns

approximately 6"/15 cm from end of jacket.

Termination With:

SSF

Micro Distribution 250 µm Fibers

Required Tools

a. Fiber Optic Strippers

b. Aramid Shears

c. Pliers

d. Ruler

e. Tape

f. Marker

3. Using the fiber strippers' 2.0 mm opening,

6. Slide housing over exposed fibers. For six

remove the jacket at marking so that the

exposed fiber is equal to the breakout tubing

and assembly plus 6" or 15 cm.

fiber kit, place fibers 1-6 all on one side of

housing. If installing 12 fiber kit place fibers

7-12 on other side.

cleerlinefiber.com

Revise #1.5