Artila Matrix 504 Handbuch zur Schnellinstallation - Seite 2

Blättern Sie online oder laden Sie pdf Handbuch zur Schnellinstallation für Desktop Artila Matrix 504 herunter. Artila Matrix 504 7 Seiten. Arm9-based embedded computer

Seite drucken

Ready LED

After Power ON, Matrix 504 starts booting. Once system is boot up,

the Ready LED will show solid green. The Ready LED will be

turned off after Matrix 504 received "halt" command.

Link/Act LED

When Ethernet port are connected to the network, Link/Act will show

solid green and if there is traffic in the Ethernet, this LED will flash

Serial Port LED

These four dual color LEDs indicate the data traffic at the serial ports.

When RXD line is high then Green light is ON and when TXD line is

high, Yellow light is ON.

Serial Port

The four serial ports can be configured as RS-232, RS-422 or RS-

485 by software. They use RJ45 connector and the pin

assignment are shown as following table.

Port 1: RS-232/422/485

RS-232: RXD,TXD,RTS,CTS,DSR,DTR,DCD,GND

RS-422: TXD+, TXD-,RXD+,RXD-,GND

RS-485: DATA+,DATA-,GND

Port 2/3/4:

RS-232: RXD,TXD,RTS,CTS,DSR,DTR,DCD,GND

RS-485: DATA+, DATA-, GND

Serial Console Port:

Serial console port is used for locally accessing Matrix 504

system using RS-232 port. The console port uses RJ45 connector

and is next to Ethernet port. Therefore please be careful to plug

in the right connector

Port 0: RS-232:RXD,TXD,GND

Therefore you need to prepare or purchase the serial console

cable (CB-RJ2CON-100) in order to use the serial console port .

In addition to the serial console signal, the console RJ45 port also

provides GPIO ( programmable I/O signal) function. The GPIO

port is CMOS I/O and can be programmed as digital input or

output. Power up setting is digital input mode with 75K ohm pull

up resistor.

Power Connector

Connect the 9 to 48VDC power line to Matrix 504. If the

power is properly supply, the power LED will show a solid

green color.

Ethernet Port

The Ethernet Port use RJ45 connector

Console