Clek Liingo Handbuch

Blättern Sie online oder laden Sie pdf Handbuch für Autositz Clek Liingo herunter. Clek Liingo 2 Seiten. Removing/installing canopy rod

Removing/Installing Canopy Rod

REMOVING CANOPY ROD

Step 1

Extend canopy: Grasp zipper tab and unzip canopy extension, then grasp front of

Canopy and pull it forward.

Step 2

Locate canopy rod in canopy hub and gently pull up at the base to remove it from

the canopy hub, as shown in Figure 1. Repeat on the other side.

Step 3

Remove canopy rod from canopy sleeve by pulling gently.

INSTALLING CANOPY ROD

Step 1

Position canopy rod so that the ends are facing away from you and curving up, as

shown in Figure 2.

Step 2

Use right hand to pick up the right side of the canopy rod and insert end through

bottom of elastic loop on the left side of canopy, as shown in Figure 3.

Step 3

Insert end of canopy rod into canopy sleeve, as shown in Figure 4.

Push canopy rod through canopy sleeve until the end of the canopy rod comes out

the other side. If the canopy fabric bunches, it may be necessary to slide the canopy

fabric along the canopy rod from the top of the canopy as the canopy rod reaches

the right side of the canopy.

Step 4

Insert end of canopy rod through top of elastic loop on right side of canopy, and

even the canopy rod out.

Step 5

Insert end of canopy rod into hole in canopy hub and push down to make sure it is

fully seated, as shown in Figure 5. Repeat on other side.

Step 6

Check to make sure that both ends of canopy rod are through the elastic below the

canopy sleeve on each side of the canopy, and fully inserted into the hole in the

canopy hub.

Figure 1

Figure 2

Figure 3

Figure 4

Figure 5