Custom Crimp PLC Series Benutzerhandbuch - Seite 7

Blättern Sie online oder laden Sie pdf Benutzerhandbuch für Prüfgeräte Custom Crimp PLC Series herunter. Custom Crimp PLC Series 19 Seiten. Test bench

Seite drucken

TEST BENCH CONNECTIONS / OPERATION

TEST BENCH CONNECTIONS:

• Connect a water source (standard garden hose connection) to the water inlet connection located at the

rear of the control cabinet.

Note:

Water supply pressure should not exceed 100 psi. If a water pressure booster pump is on the tester,

the water pressure should not exceed 50 psi. Damage to the booster pump can occur and can lead to water

leaks that can be fairly significant.

• Connect a water drain hose (standard garden hose connection or barbed fitting) to the water drain

connection located at the rear of the test cabinet. Run the drain to an appropriate drainage area.

• Connect an air supply of no more than 90 psi to the air inlet. Make sure the air lubricator is filled with oil.

This must be checked periodically to assure proper operation of the pump.

(Drip rate: 1 drip per 20 pump cycles).

Note:

Air pressure greater than 90 psi can damage vital equipment on the tester.

• Plug in electrical cord to a standard 15 amp 110VAC outlet.

TEST BENCH OPERATIONS:

• Prior to operating the bench, make sure that the pressure regulator (throttle) knob is adjusted all the way

out (counterclockwise). The air pressure gauge on the front of the control cabinet should read 0 psi.

• Follow the screen prompts to input the desired test parameters.

• Raise the tank lid and connect hose to the tested to the manifold block.

Note:

The manifold block standardly has 6 useable ports, 4 on the main face and 2 along the top. The ports

are standard with either HF4 (High Pressure) or LM9 (Medium-Low Pressure) connections. These are cone

and seat style connections.

• Secure any unused ports with the supplied plugs.

• Bleed the hose of air. Use the Fill Hose feature to fill the hose with water (or whatever fluid media is

being used).

Note:

This "Fill Hose" feature can be found on the Review Parameters screen, refer to test procedure

page.

Innovating SMART Hose Assembly Solutions Since 1979