DK Digital RSU-100 Benutzerhandbuch - Seite 8

Blättern Sie online oder laden Sie pdf Benutzerhandbuch für Radiowecker DK Digital RSU-100 herunter. DK Digital RSU-100 17 Seiten. Digital clock radio with sd/mmc card & usb support

Seite drucken

1. Radio Operation

Operation of the clock radio

General operation

Switching on

First switch the mains switch on the unit's rear panel to the "I" position. The device is

now in standby mode and the display will be illuminated by dim blue light.

To turn the system on, press

The blue display will then brightly be illuminated and the system is working. You can

change the mode by pressing the FUNCTION button repeatedly:

TUNER

UDISK

(USB flash media) -

Setting the time

1. To do this, press the ENTER button once. "

button on the remote control, then the hour digits will start to flash.

2. Now you can enter the actual hours in the present time using the

To confirm, press

3. Now you can set the minutes of the actual time using

. To confirm, press

Changing the volume

To increase the volume, turn the VOL knob in a clockwise direction. To reduce the

volume, turn the knob in the opposite direction. Alternatively, you can also regulate

the volume using the VOL + / — buttons on the remote control. To mute the

volume, press

. Press the button again to turn the volume back on

EQ presets

We have programmed some EQ sound settings into the system which you can call up

for the music you are playing. Press EQ repeatedly to activate the following

ROCK

JAZZ

settings:

setting will be displayed. FLAT stands for "neutral".

Headphone operation

You can connect a headphone to the EARPHONES jack on the rear panel of the

device using a 3.5mm jack plug. This deactivates the built-in speaker.

Be careful with regard to your hearing. A too high volume may lastingly

impair the hearing ability of your ears.

BASS

If you would like to boost the low frequencies in 3 levels, repeatedly press the BASS

button. Press the button again to deactivate this function.

Switching off

To switch the unit off, press the

the mains you should switch off the mains switch on the rear panel if you're not

going to use the device for a longer period of time. In this case the clock time is not

saved. After switching on the device you have to reset the clock.

button on the front panel or on the remote control.

SD/MMC

on the remote. Then the minute digits will start to flash.

on the remote. The time is now saved.

CLASSIC

POP

, . The first time you press this button, the current

button. As this doesn't disconnect the device from

(memory card) -

CLOCK

" will then show. Press the

AUX

buttons.

. To confirm, press