Artison LRS Benutzerhandbuch - Seite 6
Blättern Sie online oder laden Sie pdf Benutzerhandbuch für Redner Artison LRS herunter. Artison LRS 10 Seiten. Surround satellites (left, ight, surround)
Seite druckenWiring and Mounting the LRS Speakers
14. Carefully lift the speaker into position.
15. Wire the left and right channels the same as any other surround speaker. Connect the left
positive and negative of one end of the wire to the receiver / amplifier. Connect the left
positive and negative to the speaker terminals located on the rear of the speaker.
16. When connecting the speaker wire to your LRS make sure that the positive and negative
terminals are correctly attached to the positive and negative of the speaker wire.
17. Strip the ends of the speaker wire approximately 1/2" and twist the wires tightly.
18. Connect the wire to the rear of the LRS by pressing on the speaker terminal; this will open
a hole on the side of the terminal. Slip the end of the stripped wire into this hole and
release the terminal. The terminal should now securely hold the wire in place.
19. While placing the speaker into position be sure that the wires do not get pinched between
the bracket and the speaker.
20. Using the four screws that you removed in step #6 remount the speaker to the mounting bracket.
a. Insert the screws and tighten by turning in a clockwise direction.
b. Be careful to not over tighten the screws.
21. The LRS-IW uses a simple dog leg attachment method that is used to clamp the speaker to
the wall. After wiring the speaker as shown above place it into the previously cut hole and
use a screwdriver to tighten the attachment screws until the speaker is tight to the wall.
Attaching the Grilles
22. Remove the grille from the plastic bag.
23. Attach the grilles by lining the side of the grille with the one side of the speaker and partially
insert into the grille slot.
24. You can use SLIGHT pressure if necessary to "squeeze" while fitting it into the grille slot
on the opposite side of the speaker. The grilles will spring back into shape creating a pressure
fit. Refer to Diagram 4
Diagram 4
Setting up the Receiver
' , _
:r"
The Dolby High Pass Setting in most receivers is 80Hz when set in the SMALL speaker position.
We have optimized the LRS Surround Channels for this setting. The receiver should be set so
that the main speakers operate in this mode. This will provide the dynamics needed for movies
and will allow the system to be played at loud levels with very low distortion.
5