Artison MNT-STUDIO-TV Installationshandbuch - Seite 2

Blättern Sie online oder laden Sie pdf Installationshandbuch für TV-Halterung Artison MNT-STUDIO-TV herunter. Artison MNT-STUDIO-TV 2 Seiten. Studio soundbars tv mount

Seite drucken

Bracket Installation

Attach Soundbar Brackets to TV

The steps below detail the process for attaching the bracket to the

back of the TV.

1. Choose the desired mounting bracket. Use the Bracket Selection

table on the previous page.

2. If necessary follow the instruction in the Change Bracket Type

section on the previous page.

3. Remove the TV from the Mount/Stand.

4. Place the TV display side down on a soft non-abrasive surface

5. Remove any existing mounting bracket and screws from the VESA

mounting points.

VESA

mounting points

6. Gently place the Soundbar face down on the same surface as the

TV, as to not damage the front tweeters.

7. Align the Soundbar to the desired location above or below the TV.

8. Adjust the length of the mounting brackets and align the mounting

brackets to the TV's VESA points.

9. Insert undermount spacer.

Brackets

Aligned with the VESA mounting points

10. Attach the mounting bracket to the TV. The soundbar brackets

should be between the TV and the TV mount. Hand tighten the

VESA bolts only at this time.

Studio Soundbar TV Mount Installation Guide | 009-2001-00

UMB Stabilizers

It is recommended to use the UMB stabilizers for added stability,

however for smaller TVs it may not be necessary. Refer to the UMB

Stabilizers steps below before proceeding to the Attach Soundbar to

Brackets section.

1. Locate a section of the TV's chassis as close to the end of the

2. Clean the intended attachment area on the TV chassis with an

3. To install the Slider Arm, first screw one of the Stabilizer Nuts onto

4. Once in place, peel the red backing film off of the base and stick

5. Install the second nut onto the threads and tighten both in place to

Undermount

6. Break off the any additional thread of the stabilizer with a pair of

Spacer

Attach Soundbar to Brackets

The steps below detail the process for attaching the Soundbar to the

mounting brackets after the TV is installed onto the original mount/

stand.

1. Reattach the TV onto the mount/stand.

2. Adjust the height of the Soundbar bracket.

3. Attach the optional extension brackets if needed.

4. Align the mounting slides in the Soundbar.

5. Attach the Soundbar to the mounting bracket.

6. Tighten all mounting bolts and screws.

Slider Arm that is flat enough to mount the stabilizer foot

preferably close to the edge of the TV.

alcohol wipe to remove any latent grease.

the thread, close to the swivel base. Place the assembly underneath

the Slider Arm and insert the threads through the Arm slot.

firmly to the TV chassis.

hold the speaker brackets in the correct placement.

Back of the TV

Mounting Bracket

UMB Stabilizer

pliers.

NOTE: If the L/C-Shaped bracket does not slide easily loosen the

VESA bolts 1/2 turn.

45 Perseverance Way, Hyannis, MA 02601

www.savant.com/artisonspeakers

L-Shape Bracket shown here

Optional Extension Bracket

| 508.683.2500