DK2 12SPS12 Montage- und Betriebsanleitung - Seite 6

Blättern Sie online oder laden Sie pdf Montage- und Betriebsanleitung für Winden DK2 12SPS12 herunter. DK2 12SPS12 20 Seiten. Electrical winch

6. Assemble the Clevis Hook to the cable. Take off the pin from the Clevis Hook,

connect the Clevis Hook to the cable and mount the pin back to the Clevis

Hook.

7. Always use the Hand Saver when free-spooling and re-spooling the wire rope.

Using the Hand Saver keeps your hands and fingers away from the rotating

drum.

8. Check for proper drum rotation. Pull and turn the clutch knob to the "off"

position (Free-spooling). Pull out some cable from the drum, and then turn the

clutch knob to the "In" position to engage the gears. Press the cable out button

on the power switch. If the drum is turning and releasing more cable then your

connections are accurate. If the drum is turning and collecting more cable then

reverse the leads on the motor. Repeat and check rotation.

WARNING – DO NOT EXCEED RATED CAPACITY.

WARNING – Intermittent use only.

WARNING - Do not use winch in lifting or moving or persons.

WARNING - A minimum of five wraps of cable around the drum

barrel is necessary for pulling and holding the rated load. The

cable clamp is not designed to hold the load without 5 wraps of

cable around the barrel.

WARNING - Keep yourself and others a safe distance to the

side of the cable when under tension.

WARNING – The wire rope may break before the motor stalls.

For heavy loads at or near rated capacity, use a pulley

block/snatch block to reduce the load on the wire rope.

WARNING -Never step over a cable, or near a cable under load.

WARNING - Don't move the vehicle to pull a load (towing) on

the winch cable. This could result in cable breakage.

SAFETY PRECAUTIONS

WARNING