Customer Minded Associates Nesting Work Table Montageanleitung - Seite 2
Blättern Sie online oder laden Sie pdf Montageanleitung für Inneneinrichtung Customer Minded Associates Nesting Work Table herunter. Customer Minded Associates Nesting Work Table 2 Seiten.
Nesting Work Table
Parts List & Assembly Instructions
NOTE: Please refer to Drawings & Parts List for quantities and descriptions before starting.
Tools needed: Phillips Head screwdriver, two 10MM wrench & one 19MM wrench, or 2 adjustable wrenches
STEP 1: Attach Top and Middle Cross Braces with Bracket holes facing up to T-Frames using (4)1&5/8" Black Bolts and Lock Nuts.
Do not tighten until Bottom Cross Brace is installed (see drawing).
STEP 2: Attach Bottom Cross Brace using (2) 1&5/8" Black Bolts and Lock Nuts in (2) horizontal holes at bottom of T-Frames.
Tighten Top, Middle and Bottom Cross Braces until snug (see drawing).
STEP 3: Install (4) Casters and (4) Bumpers by sliding Bumpers over Caster stems then inserting Caster stems through the Pre-set
holes on all (4) bottom corners of T-Frames. Tighten large Caster Lock Nuts on Caster Stem until snug.
STEP 4: Position flat side of (2) Angled U-Channels on underside of Grey Wood Top indicated by (6) pre-set holes with threaded
inserts so that narrow end of Angled U-Channel is closest to Wood Top Edge (see drawing). Using (6) Phillip head screws, install
both Angled U-Channels in pre-set holes of Grey Wood Top until snug. Do not over-tighten.
STEP 5: Install (2) Rectangle U-Channels to Top Cross Brace's pre-set Brackets with flat side of U-Channel facing up. Insert Codder
Bolt through U-Channel and Bracket to hold in place. Then secure by inserting Pin in hole of Codder Bolt. Install remaining (2)
Rectangle U-Channels to Middle Cross Brace's pre-set Brackets using Codder Bolts and Pins. Important: All Rectangle U-Channels
should be installed on same side of unit.
STEP 6:Install Grey Wood Top to Top Cross Brace. Hold Wood Top so that Angled U-Channels are facing Brackets with Angled U-
Channels facing down. Line up slots of Angled U-Channels with holes in Brackets. Hold in place and insert Codder Bolts, then
secure with Pins.Install Black Shelf to Middle Cross Brace on same side of unit as Grey Wood Top using same procedures as Grey
Wood Top installation.
STEP 7 : Install Telescoping Hanger Bar to either side of T-Frames. First install Outer Sleeve with adjustment holes closest to Top
Cross Brace. Line up Outer Sleeve tabs so they overlap corresponding T-Frame holes located between Top and Middle Cross
Braces. Using Black Bolts and Lock Nuts secure in place. Attach Hanger Bar to Inner Sleeve using Push Pin closest to Inner Sleeve
end. Slide opposite end of Inner Sleeve into Outer Sleeve so that remaining Push Pin lines up with Outer Sleeve adjustment holes
until it clicks in place at desired height. Note: Hanger Bar can be installed in all four directions as desired. When not in use,
position Hanger Bar so that bar extends inward over Wood Top for safety.
Customer Minded Associates, Inc.
Ph. 800-682-5840 or 813-949-2323
www.customerminded.com