Customidea GeoPic II Gebrauchsanweisung - Seite 13

Blättern Sie online oder laden Sie pdf Gebrauchsanweisung für Kamera-Zubehör Customidea GeoPic II herunter. Customidea GeoPic II 20 Seiten. Geotagging device for nikon d200/d2hs/d2x/d2xs fuji s5 pro

Seite drucken

There may be occasions when it is desirable to

continually send buffered GPS data to the camera in the

same way as the continuous (red) mode. This would

result in higher power consumption, but there would be

no delay before the camera is ready to geotag photos.

This behaviour can be enabled if desired (see the setting

section) and results in the following behaviour:

Status light:

slow flashing

always on

Provided that continuous sending of data in the freeze

mode is not enabled, your camera will happily leave its

high power metering state when it has seen no activity

for a period of time. This contributes to significantly

increased battery life whilst in the freeze mode, because

the camera uses only a tiny amount of power in its

standby state.

Unlike the low power (green) mode, the GPS module

within the GeoPic II is turned off during freeze mode

(unless searching for a new position). The power

consumed by the GeoPic II in freeze mode is therefore

much lower than both the other modes of operation. This

combined with the camera being allowed to enter its

standby state results in the lowest overall power

consumption.

Nikon D200, D2HS, D2X and D2XS and Fuji S5 Pro are registered

trademarks or a trademark of their respective companies.

Function button:

Cancels the

search and uses

previously

buffered data

(Mode change

with half press)

Starts a new

search, to update

the buffered GPS

data

(Mode change

with half press)

Freeze mode (blue)

Description:

The GeoPic II has switched on its

internal GPS module and is waiting

for a good lock so that it can store

this location in a buffer and use it for

subsequent geotagging. The

camera's GPS icon will not be

visible in its display.

The GeoPic II has good buffered

data and is continuously updating

the camera with the buffered GPS

location. GPS data is sent

regardless of the camera state. The

camera's GPS icon will be visible in

its display.