CustomWorks NITRO ROCKET KIT 0715 Handbuch - Seite 14

Blättern Sie online oder laden Sie pdf Handbuch für Motorisiertes Spielzeugauto CustomWorks NITRO ROCKET KIT 0715 herunter. CustomWorks NITRO ROCKET KIT 0715 16 Seiten.

Seite drucken
CONGRATULATIONS!!!
CONGRATULATIONS!!!
CONGRATULATIONS!!!
CONGRATULATIONS!!!
CONGRATULATIONS!!!
new Custom Works Rocket! In the next section of this manual you will find some basic setup
hints and advice. It is important to remember that all tracks and racing surfaces are different.
Therefore the suggestions we give you are general in nature and should by no means be
treated as the only options.
MAINTENANCE:
MAINTENANCE:
MAINTENANCE:
MAINTENANCE:
MAINTENANCE:
Occasionally dirt will get into the moving and pivoting locations in your car. It is best to
periodically clean your car to keep all the suspension components moving freely. Read the tips
below to keep your car running at its best!
- Begin by removing the majority of the dirt using a small brush, toothbrush, or compressed air.
- Compressed air is ok to use, be mindful to not FORCE the dirt into the radio gear, transmission,
bearings, or air filter. Typically these items only have dirt on them, hitting the dirt with the
compressed air puts dirt IN
- Tires, either foam or rubber are best cleaned using water or cleaners like Simple Green (TM). Simple
Green also does a great job cleaning car parts as well. Lightly spraying car parts (NOT radio
components, transmission, air filter, or bearings) with Simple Green and blowing off with compressed
air or wiping the parts using the paint brush is a great way to clean in a hurry.
- Another R/C friendly cleaner is WD-40 (TM). After the car is clean, very lightly spray the car
components and bearings (NOT radio components, transmission, or air filter). Use your brush or
compressed air to remove the extra WD-40. This will lube your bearings and leave a protective
coating on the parts making it easier to remove dirt later.
- Differential Maintenance is needed when the action of the diff feels "notchy". Usually cleaning the
diff parts, re-sand the thrust and diff plates with 400 paper, and lube appropriately will be all that is
needed to bring back to new. Ignoring your differential will lead to handling woes and increase
transmission temps, which will cause part failure.
TUNING TIPS:
TUNING TIPS:
TUNING TIPS:
TUNING TIPS:
TUNING TIPS:
None of these "tips" are EVER set in stone. On any given day this manual or any chassis
engineering book or guru can be proved wrong by the stop watch. A good way to approach
chassis set-up is to try one change, practice it, think how the car felt different from before, and
compare lap times from the stop watch.....this will never fail.
Car Pushes (understeers):
Car Pushes (understeers):
Car Pushes (understeers):
Car Pushes (understeers):
Car Pushes (understeers):
- Decrease Spoiler on Body
- Heavier Rear Spring
- Softer Front Spring
- Use Rear Sway Bar
- Try Softer Front Compound Tire
- Try Harder Rear Compound Tire
- Lower Front Ride Height
- Raise Rear Ride Height
- Thread Shock Collar UP on
Right Front
- Thread Shock Collar DOWN on
Right Rear
- Decrease Rear Toe
- Decrease Castor
- Add Rear Toe Stagger or
Increase the difference
You have now completed the assembly process of your
IN these parts!
IN
IN IN
These are some general guidelines for optimizing handling performance.
Car Is Loose (oversteers):
Car Is Loose (oversteers):
Car Is Loose (oversteers):
Car Is Loose (oversteers):
Car Is Loose (oversteers):
- Increase Spoiler Angle
- Softer Rear Spring
- Heavier Front Spring
- Use Front Sway Bar
- Try Harder Front Compound Tire
- Try Softer Rear Compound Tire
- Raise Front Ride Height
- Lower Rear Ride Height
- Thread Shock Collar
DOWN on Right Front
- Thread Shock Collar UP on
Right Rear
- Increase Rear Toe
- Increase Castor
- Decrease Rear Toe Stagger or
Decrease the difference
Car Is Erratic:
Car Is Erratic:
Car Is Erratic:
Car Is Erratic:
Car Is Erratic:
- Bent Suspension Pins: Remove shocks to check
free movement.
- Bound Ball Joint: Should spin free on balls
while mounted to the car.
- Bent or Loose Camber Links
- Wore out Bearings or Completely Seized
Bearings
- Chunked Tire: Check to see if Foam or Rubber
Tire is still glued to wheel.
- Loose Screws: Especially Chassis Screws, add
Blue Loctite to prevent.
- Shocks: Either Bound-up or Out of Oil. Must
swivel freely on mounts.
- Foreign Objects: Unlucky Dirt/Stones
preventing Suspension or Steering Movement.
- Blown Differential
- Radio Problem: Bad Servo, Weak Servo Saver
Spring, Transmitter Pot blown.