Alunar M508 Prusa i3 Schnellstart-Handbuch - Seite 4

Blättern Sie online oder laden Sie pdf Schnellstart-Handbuch für 3D-Drucker Alunar M508 Prusa i3 herunter. Alunar M508 Prusa i3 6 Seiten. Diy 3d printer kit

Seite drucken

B.Preinstallation Checklist

1. Step Way of Opening Box: Please look over the whole box appearance and make sure whether the box

is damaged( if damaged, please feel free to contact with our customer service ); And then please open

the box and check the kits list as per "sketch map of opening carton" and "Video of opening carton"

（SD-Card:\Manual&AssemblyVideo\1-Open the carton）.

Take an account of kits: Please check out all the parts and make sure if any part is lost or damaged as

per the "Packing List" and video "Check out the kits". Please feel free to contact our customer service

once you find out that you lost or got any defective parts (except leading by the unartificial reason). We

will try our best to settle your problems as soon as possible ( SD-Card:\Manual&AssemblyVideo\1-Open

the carton）.

C.Assembly and Calibration for M508

1. M508 assembly: Please assembly the printer by following the step1- step7 on assembly diagram and

video, and pay attention the prompt for key of assembling.

Testing and Commissioning

（1） Power on test: When connecting the power supply to your printer, please make sure whether the

power indicator light is on, LCD screen show correctly or not, hotbed and the extruder can be

heated rightly or not, the thermistor, turbine fan and radiator fan works normally or not;

（SD-Card:\Manual&AssemblyVideo\2-Assembly and debugging\2-Power on inspection）

（2） Hotbed leveling test: Please make calibration to level the hotbed according to the video

（SD-Card:\Manual&AssemblyVideo\2-Assembly and debugging\3-Hot bed leveling）

（3） Change the Filament: Watch the video "how to change the filament " and get the operation way of this

special feature of this printer(SD-Card:\Manual&AssemblyVideo\2-Assembly and debugging\5-Change

filament）

（4） Feature Demonstration: watch the video "Basic Feature Demostration" and get the operation way

of all basic feature;（SD-Card:\Manual&AssemblyVideo\2-Assembly and debugging\4-Function

introduction）

D. Printing Test:

After all the above-mentioned test and you make sure the printer works well. Now you can get start a

：