CUTS DIAMANT MC400YM Benutzer- und Wartungshandbuch - Seite 4

Blättern Sie online oder laden Sie pdf Benutzer- und Wartungshandbuch für Kutter CUTS DIAMANT MC400YM herunter. CUTS DIAMANT MC400YM 4 Seiten.

Seite drucken

5) STORAGE, LIFTING

AND TRANSPORT

5.1) WARNINGS

To avoid damage caused by incidental fall of the machine,

always make sure that people keep at a safe distance from

the forklift.

ATTENTION!

Lifting, transport, installation and maintenance must be performed

by qualified technicians. Before handling the machine, make sure

that the forklift is suitable for supporting the load.

5.2) JOINT CUTTER LIFTING

The total weight of the machine varies according to the

model. Maximum weight 143 kg

It is strongly recommended to use a forklift equipped with forks of at least 2 metres

length to lift and handle the machine. Make sure that the forks extend beyond the

opposite side.

5.3) TRANSPORT

• Use the lifting hook to load and download the machine and use suitable means

of transport

• Do not use the joint cutter's handles to lift the machine

• Make sure that the ramps used to load/unload the machine are properly fixed,

stable and suitable for bearing the weight of the machine

• When carrying the machine, fix it so as to prevent it from tilting over or sliding

about

• For very long transits, empty out the fuel tank completely

6) MAINTENANCE, STORAGE,

DEMOLITION AND DISPOSAL

6.1) MAINTENANCE

MACHINE MAINTENANCE

• Maintenance and repair must be performed under the supervision of the person

appointed by the employer

• When maintenance is done to the machine, the engine must be off

• Everyday check tension of V-belts. Replace belts if worn out (replace the whole set)

(V-belts)

• Check the efficiency of the blade cooling system (tank, connectors, nozzles)

• Clean filters regularly

• Every 100 hours of operation inject grease into the greasing system of the wheel

support, blade shaft supports and hand-wheel support

• Every 100 hours of operation overhaul all components of the machine

• Drain fuel out completely at least once a year

• In case of inactivity for more than 48 hours, empty out the fuel tank completely

and eliminate condensation water

• In case of prolonged inactivity, additives must be added to the petrol to avoid

damage to the engine

(V-belts tension device)

ENGINE MAINTENANCE

COMPONENT

Daily maintenance:

• check the filter and replace it if necessary

Air filter

• for the models with oil bath filter check the oil level (1)

• check tightness of tank cap and replace it if necessary (2)

• check fuel filter every 100 hours of operation and replace

Fuel tank

it if necessary (6)

• check the oil level and top up if needed (3)

Engine

• first oil change after 20 hours of operation (3-4)

V-belts

• check tightness monthly (5)

Yanmar

6.2) STORAGE

In case of prolonged inactivity, store the joint cutter in a dry and sheltered place.

Temperatures below -10° C and above +60° C could cause serious damage to the

machine.

It is prohibited to place any material or

tools on the machine

6.3) DEMOLITION AND DISPOSAL

Dispose of consumption materials and materials deriving from demolition following

the regulations in force in the country where you are working.

MAINTENANCE

Honda/Robin