Cutting Edge GL2100 Benutzerhandbuch - Seite 7

Blättern Sie online oder laden Sie pdf Benutzerhandbuch für Datenlogger Cutting Edge GL2100 herunter. Cutting Edge GL2100 18 Seiten.

3.1.3

3.1.4

3.2 Pin out Assignment and Description

3.3 The Globalstar antenna is attached by the SMA connector located at the front of the unit.

3.3.1

3.4 Cautions and Warnings

3.4.1

3.4.2

3.4.3

3.4.4

3.4.5

Page | 7

The second LED is lit when there is a pending transmission.

The external serial port is where the device receives its data. This port requires

a RS232 signal.

Ensure the antenna has a clear view of the sky.

It is important to ensure that the correct polarity is observed when powering up

the GL2100. Ensure that all power and grounds are applied only where

specified. Damage to the unit may result if power or ground is applied to the

wrong junction.

DO NOT remove factory installed screws. Damage to the units may result and

void any warranties.

DO NOT install near heat sources such as direct sunlight, warm air exhausts, or

heaters

NO scheduled maintenance is required to ensure continued functionality.

ESD (Electro Static Discharge) guidelines shall be followed.

Pin #

Board

Pos 4-32VDC Red

Neg

Serial Rx

PG2

Serial Tx

PG3

Output

PG1

Colour

Black

Yellow

Orange

White

Blue

Green

Purple