ALUZ A1-ZIBI-STN-DWH Handbuch - Seite 10
Blättern Sie online oder laden Sie pdf Handbuch für Beleuchtungsanlagen ALUZ A1-ZIBI-STN-DWH herunter. ALUZ A1-ZIBI-STN-DWH 13 Seiten.
Seite drucken1
Determine number of louvers needed. Louvers are available in 1'
increments. Specify total length of reflectors needed.
2
Position louvers on luminaires, then install 3 set screws on each
louver segment to secure in place. Do not over-tighten set screws
1170 N Red Gum St, Anaheim, CA 92806
aluz.lighting
© ALUZ All Rights Reserved. ALUZ reserves the right to make changes or withdraw specifi cations without prior notice.
A1 Series | Surface
ZIBI Standard Dynamic White
(A1-ZIBI-STN-DWH)
866.ALUZ.LTG | 714.535.7900
3
If applicable, connect disconnects between luminaires. Slide
shrink tube over connectors and apply heat. The shrink tube will
shrink down, sealing the connectors. Apply silicone around sealed
connectors for a stronger seal.
4
Mount luminaires at least 12" away from the wall.
Page 10 of 13
Louver (A1-ZIBI-STN-LVR)
12"
Installation Instructions
9 / 11 / 2023 / Rev 4