ALUZ A1-ZYZY-SQR Installationsanleitung Handbuch - Seite 10
Blättern Sie online oder laden Sie pdf Installationsanleitung Handbuch für Beleuchtungsanlagen ALUZ A1-ZYZY-SQR herunter. ALUZ A1-ZYZY-SQR 11 Seiten.
Seite druckenZYZY
Square
A1-ZYZY-SQR
1
In the event of a driver failure, the luminaire is easily opened to replace
defective driver.
2
Unmount luminaire from mounting clips and remove bottom cap. Use a
flathead screwdriver to gently pry bottom cap from extrusion.
Bottom Cap
3
Push on buttons on terminal block to release wires, then remove wires.
Note: Do not bend, deform, or pull wires.
Terminal Block
ALUZ
1170 North Red Gum Street, Anaheim, CA 92806
Phone: 800 921 2254 or 714 535 7900 | Fax: 714 535 7902 | [email protected] | aluz.lighting
© ALUZ All rights reserved. ALUZ reserves the right to make changes or withdraw specifi cations without prior notice.
4
Loosen hex nut assembly using an 11/32 socket, then slide away from slot to
release driver. Repeat for other side of driver.
Do not disassemble hex nut assembly.
Hex Nut Assembly
5
Remove defective driver from extrusion and replace with a new, compatible
driver. Mount driver to extrusion using hex nut assemblies, then reconnect wires.
Note: Consult factory if unsure about driver compatibility.
Installation Instructions
9 / 1 / 2021 / Rev 0
Page 10 of 11
Driver Replacement
Driver